How To Perform The Cisco Unified Videoconferencing 3500 Gateway Unit Initial Configuration; About The Initial Configuration And Boot Phases - Cisco 3522 BRI Installation And Upgrade Manual
Cisco unified videoconferencing gateway releases 5.6 and 5.7
Hide thumbs
Also See for 3522 BRI:
- Online help manual (8 pages) ,
- Installation and upgrade manual (52 pages)
Table of Contents
Advertisement
How to Perform the Cisco Unified Videoconferencing 3500 Gateway Unit Initial Configuration
Figure 2-4
Pass the screws through the brackets and tighten them into the screw holes on each side of the
Step 4
Cisco Unified Videoconferencing 3500 Gateway unit using a suitable screwdriver.
Insert the Cisco Unified Videoconferencing 3500 Gateway unit into the 19-inch rack.
Step 5
Fasten the brackets to the side rails of the rack.
Step 6
Make sure that the air vents at the sides of the Cisco Unified Videoconferencing 3500 Gateway unit are
Step 7
not blocked.
How to Perform the Cisco Unified
Videoconferencing 3500 Gateway Unit Initial Configuration
•
•
•
•
•
About the Initial Configuration and Boot Phases
Initial monitoring and administration of the Cisco Unified Videoconferencing 3500 Gateway unit are
performed from a remote PC via a serial connection. This allows you to access the boot configuration
menu of the Cisco Unified Videoconferencing 3500 Gateway unit. At power-up, the Cisco Unified
Videoconferencing 3500 Gateway unit goes through the following boot phases:
•
•
•
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Releases 5.6 and 5.7
2-6
Fitting a Bracket for Rack Mounting
About the Initial Configuration and Boot Phases, page 2-6
Connecting to a PC, page 2-7
Setting the IP Address, page 2-7
Setting Ethernet Speed and Duplex Parameters, page 2-9
Changing the Configuration Tool Login Password, page 2-10
Auto-boot—The embedded operating system initializes and displays basic information.
Configuration menu—A 6-second countdown allows you to enter the configuration menu.
Initialization—The Cisco Unified Videoconferencing 3500 Gateway unit completes its boot
sequence and is ready for operation.
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
OL-17010-01
Advertisement
Table of Contents
