Inserting The Flash Memory Simm - Cisco AS5350 Installation Manual

Cisco systems universal gateway chassis installation guide

Hide thumbs Also See for AS5350:

Table of Contents

Appendix

Figure A-7

Caution

Some Flash memory SIMMs have the components mounted on the rear side. To prevent damage when

you insert the SIMM, always use the polarization notch as a reference, not the position of the

components on the SIMM.

Insert the new SIMM by sliding the end with the metal fingers into the appropriate SIMM socket at

Step 8

approximately a 45-degree angle to the system board as shown in Figure A-8.

Figure A-8

Gently rotate the SIMM until the latch on either side snaps into place. Do not use excessive force because

Step 9

the connector might break. When inserting the new SIMM, make sure that the polarization notch is

located at the right end of the SIMM socket.

78-10754-03 0A

Removing the Flash Memory SIMM

Inserting the Flash Memory SIMM

Cisco AS5350 Universal Gateway Chassis Installation Guide

Replacing Flash Memory SIMMs

-11

Table of Contents