Power-Button Board; Removing The Power-Button Board - Dell Latitude 5430 Service Manual
Hide thumbs
Also See for Latitude 5430:
- Service manual (139 pages) ,
- Service handbook (110 pages) ,
- Setup and specifications (32 pages)
Table of Contents
Advertisement
Steps
NOTE:
The system board can be removed and installed with the thermal module attached in order to simplify the procedure
and preserve the thermal bond between the system board and heat-sink. In order to do so, technicians must also remove
the two (M2x5) screws to secure the system fan to the system board.
1. Slide the system board to make the USB Type-C connector to toe-in to the hinge saddle and align the screw holes on the
system board with the screw holes on the palm-rest assembly.
2. Replace the four (M2x3) screws to secure the system board to the palm-rest assembly.
3. Align and place the USB Type-C bracket on the system board.
4. Replace the three (M2x5) screws to secure the USB Type-C bracket to the system board.
5. Connect the USH board cable to the connector on the system board and close the latch to secure the cable to the system
board.
6. Connect the touchpad cable to the connector on the system board and close the latch to secure the cable to the system
board.
7. Route the coin-cell battery cable under the system board and adhere the coin-cell battery to the palm-rest assembly.
8. Route the display and eDP cable through the routing guide on the system board.
9. Connect the eDP cable to the connector on the system board.
10. Connect the display cable to the connector on the system board.
11. Adhere the tape that secures the display cable to the system board.
12. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
13. Replace the two (M2x3) screws to secure the eDP cable bracket to the system board.
Next steps
1. Install the
assembly inner
2. Install the
heat
sink.
3. Install the
memory
module.
4. Install the
WLAN
card.
5. Install the
WWAN
card.
6. Install the
M.2 2280 solid-state drive
7. Install the
3-cell battery
8. Install the
base
cover.
9. Install the
microSIM
card.
10. Install the
microSD
card.
11. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
microSIM
4. Remove the
base
cover.
5. Remove the
3-cell battery
6. Remove the
M.2 2280 solid-state drive
7. Remove the
WLAN
card.
8. Remove the
WWAN
card.
9. Remove the
memory
module.
10. Remove the
assembly inner
11. Remove the
system
board.
frame.
or
M.2 2230 solid-state
or
4-cell
battery.
after working inside your
before working inside your
card.
card.
or
4-cell
battery.
or
M.2 2230 solid-state
frame.
drive.
computer.
computer.
drive.
Removing and installing components
49
Hide quick links:
Advertisement
Table of Contents
