Table of Contents
Advertisement
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
Step 10: Completing and Saving the Configuration
When you have completed the entire configuration, the system checks for errors. If errors are
found, a warning message appears. When the configuration is error-free, you may apply and save
it.
To complete and save the configuration, complete the following steps:
Step 1
The system informs you that data collection is complete.
We recommend that you view the entire new configuration before it is applied.
Type y and press Enter.
Note that there is no default.
If there are no errors, go to step 3.
If any errors are detected, you may choose to view them.
Step 2
Press Enter.
You are asked whether to apply and save the configuration.
Step 3
If the setup is aborted, the dialog is ended.
Step 4
If there are no errors, the system requests confirmation of either a yes or no answer, in order to
prevent mistakes.
Type the appropriate answer (y or n) and press Enter.
The selected action is carried out by the system.
Step 5
If the configuration was applied and saved, you may also save it to a file at a remote station.
OL-7826-05
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied?
[yes/no]: y
Found errors in the new configuration, would you like to view them? [yes]:
The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP
access-class.
Apply and Save this configuration? [yes/no]:
•
To apply and save the configuration, type y and press Enter.
•
To abort the setup procedure without applying or saving the configuration (recommended
if there are errors), type n and press Enter.
Setup procedure aborted, no configuration changes made.
The running configuration would be overwritten by the changes you have just
entered, are you sure? [yes/no]:
•
If the apply and save action is not confirmed (no), the setup is aborted.
Setup procedure aborted, no configuration changes made.
If the apply and save action is confirmed (yes), the configuration is applied and saved.
•
The new running configuration will be saved to the startup configuration.
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
Initial System Configuration
5-23
Advertisement
Table of Contents
Troubleshooting
