Table of Contents
Advertisement
• 1/4-inch slotted-blade torque screwdriver
Parts list
The following parts are provided with the Universal Two-Post Rack Kit Installation.
Figure 17. Rack kit parts
1. Front brackets (2)
2. Rear brackets, 5-6 inch post (2)
3. Rear brackets, 3-5 inch post (2)
4. Screw, 8-32 x 5/16-in., panhead Phillips (8)
5. Screw, 8-32 x 5/16-in., flathead Phillips (16)
6. Screw, 6-32 x 1/4-in., panhead Phillips (8)
7. Screw, 10-32 x 5/8-in., panhead Phillips (8)
8. Retainer nut, 10-32 (8)
Ensure that the items listed and illustrated above are included in the kit. Note that not all parts may be
used with certain installations depending on the device type.
Flush-front mounting
Observe the following notes when using this procedure:
• The device must be turned off and disconnected from the fabric during this procedure.
• The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
• The illustrations for this procedure show a two-post rack with narrow posts (3- to 5-inch) as an
example.
• The illustrations in the rack installation procedures are for reference only and may not show the actual
device.
CAUTION: Use the screws specified in the procedure. Using longer screws can damage the device.
Chapter 3. Mounting the switch 25
Advertisement
Table of Contents
