Table of Contents
Advertisement
Battery connector (fanless products only)
Table 5-13
Battery connector description and part number
Description
Battery connector
Before removing the battery connector, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the solid-state drive (see
5.
Remove the heat sink (see
Remove the battery connector:
1.
Disconnect the battery connector cable from the system board (1).
2.
Remove the two Phillips M2.0 × 3.0 screws (2) that secure the connector to the computer.
3.
Lift the battery connector out of the computer (3).
Reverse this procedure to install the battery connector.
46
Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page
30).
Solid-state drive on page
Heat sink (thermal module) on page
27).
28).
33).
43).
Spare part number
L63585-001
- Quick Links:
- Table of Contents
- Product Description
Hide quick links:
Advertisement
Table of Contents
