Table of Contents
Advertisement
DETAILS
I T E M S
Power
(
pg. 8)
TAPE
RECORDING
(
pg. 16, 17)
Perform charging where the temperature is between 10°C and 35°C (50°F
and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
charging. If the environment is too cold, charging may be incomplete.
Charging times are for a fully discharged battery pack.
Charging time varies according to the ambient temperature and the status of
the battery pack.
To avoid interference with reception, do not use the AC Adapter near a radio.
Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
The following operation stops charging:
• Set the Power Switch to "PLAY", "
• Disconnect the AC adapter from the camcorder.
• Unplug the AC adapter from the AC outlet.
• Detach the battery from the camcorder.
When you use the LCD monitor outdoors in direct sunlight, the LCD monitor
may be difficult to see. If this happens, use the viewfinder instead.
The cassette holder cannot be opened unless a power supply is attached.
There may be a delay after you open the cassette holder cover until the
cassette holder opens. Do not use force.
Once the cassette holder is closed, it recedes automatically. Wait until it
recedes completely before closing the cassette holder cover.
When the Recording Start/Stop button is pressed, it may take a few seconds
before actual recording starts. "
actually starts recording.
The time required to calculate and display the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape used.
"TAPE END" appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes. "TAPE END" also appears
when a cassette at its end is loaded.
N O T E S
" or "
" starts rotating when the camcorder
67
EN
".
Hide quick links:
Advertisement
Chapters
Table of Contents
