KitchenAid Architect Series II KGRS206X Dimension Manual
30" (76.2 cm) freestanding gas range
Hide thumbs
Also See for Architect Series II KGRS206X:
- User manual (72 pages) ,
- Use & care manual (72 pages) ,
- Use & care manual (72 pages)
Advertisement
Quick Links
PRODUCT MODEL NUMBERS
KGRS206X
KGRS208X
GAS SUPPLY REQUIREMENTS
Gas supply line:
Provide a gas supply line of
location. A smaller size pipe on longer runs may result in
insufficient gas supply. With LP gas, piping or tubing size can
be
" (1.3 cm) minimum. Usually, LP gas suppliers determine
the size and materials used in the system.
NOTE: Pipe-joint compounds that resist the action of LP gas
must be used. Do not use TEFLON
Flexible metal appliance connector:
If local codes permit, a new CSA design-certified, 4 to 5 ft
(122 to 152.4 cm) long,
" (1.3 cm) or
flexible metal appliance connector may be used for connecting
range to the gas supply line.
A
" (1.3 cm) male pipe thread is needed for connection to
the female pipe threads of the inlet to the appliance pressure
regulator.
Do not kink or damage the flexible metal tubing when moving
the range.
Must include a shutoff valve:
The supply line must be equipped with a manual shutoff valve.
This valve should be located in the same room but external to
the range opening, such as an adjacent cabinet. It should be in a
location that allows ease of opening and closing. Do not block
access to shutoff valve. The valve is for turning on or shutting
off gas to the range.
A
A. Gas supply line
B. Shutoff valve "open" position
C. To range
Type of Gas
Natural gas:
This range is design-certified by CSA International for use with
Natural gas or, after proper conversion, for use with LP gas.
This range is factory set for use with Natural gas. See "Gas
Conversions" section. The model/serial rating plate located
behind the control panel has information on the types of gas
that can be used. If the types of gas listed do not include the
type of gas available, check with the local gas supplier.
LP gas conversion:
Conversion must be done by a qualified service technician.
No attempt shall be made to convert the appliance from the gas
specified on the model/serial rating plate for use with a different
gas without consulting the serving gas supplier. See "Gas
Conversions" section.
†®
TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
30" (76.2 cm) Freestanding Gas Range
KGRS308X
" (1.9 cm) rigid pipe to the range
tape.
®†
" (1.9 cm) I.D.,
B
C
PRODUCT DIMENSIONS
36±1/8"
(91.4±0.3 cm)
(Adjustable)
29⁷⁄₈"
(75.9 cm)
ELECTRICAL REQUIREMENTS
IMPORTANT: The range must be electrically grounded in accordance with local
codes and ordinances, or in the absence of local codes, with the National Electrical
Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is recommended that a
qualified electrical installer determine that the ground path is adequate.
A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-
delay fuse or circuit breaker is also recommended. It is recommended that a
separate circuit serving only this range be provided.
Electronic ignition systems operate within wide voltage limits, but proper
grounding and polarity are necessary. Check that the outlet provides 120-volt
power and is correctly grounded.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
30"
(76.2 cm)
25³⁄₄"
(65.4 cm)
48¹⁄₂"
(123.2 cm)
max
29¹⁄₄"
(74.3 cm)
max
door
closed
46⁵⁄₈"
(118.4 cm)
max
door
open
Ref. 316903001
Page 1 of 2
9/27/11
Advertisement
Related Manuals for KitchenAid Architect Series II KGRS206X
Summary of Contents for KitchenAid Architect Series II KGRS206X
- Page 1 The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range opening, such as an adjacent cabinet. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve.
- Page 2 Range may be installed with zero clearance to the combustible construction at the rear and on the sides below the cooktop. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.