Table of Contents
Advertisement
Set up
The following explains the procedure for network settings (set up) in order to connect the product to your
network.
For the set up of the optional Wireless LAN unit, see the Wireless LAN unit's manual.
Set up methods
There are three methods for set up.
Method 1: Set up using EpsonNet Config
This method involves installing the network configuration tool, EpsonNet Config, on your computer for
setting.
As it does not require any settings in advance to allow set up, you can easily perform set up using a
computer already connected to the network.
To download EpsonNet Config, see
Method 2: Set up using EpsonNet Config (Web version)
This method involves opening the Web application equipped in the UB-E04 from a Web browser to
perform settings.
Because you specify the printer's IP address to open it, you need to set your computer to the same
network segment as the printer.
With EpsonNet Config (Web version), you can set more items than with EpsonNet Config.
Method 3: Set up using arp/ping commands
This method involves setting the printer's IP address in the setting computer's arp/ping commands,
then using the setting tool to change the other settings.
The setting computer must be in the same segment as the printer. Also, settings can be done only
when the printer's arp+ping IP setting is set to Enable.
Use EpsonNet Config or EpsonNet Config (Web version) for settings other than the IP address.
"Downloads" on page
30.
Chapter 2 Set up
2
15
Advertisement
Table of Contents
