Table of Contents
Advertisement
Available languages
Available languages
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 35 .
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector
protection up against the product.
To do a check after the assembly
•
Make sure that all assembly instructions are
completed.
•
Make sure that no remaining parts are in the
package.
•
Make sure that the battery is prepared and
charged correctly.
•
Make sure that the bolts for the seat are
tightened and that the seat is adjusted correctly.
•
Make sure that the tires are correctly inflated.
•
For best cutting results, make sure that the
cutting deck is balanced side to side and front
to rear. Make sure that the tires are correctly
inflated for a balanced cutting deck.
•
Examine the cutting deck and the drive belts.
Make sure that the drive belts are installed
correctly around the pulleys and inner part of all
belt keepers.
Introduction
WARNING:
the safety chapter before you use the
product.
To fill fuel
WARNING:
flammable. Be careful and refuel
outdoors. Refer to
9 .
CAUTION:
type. Incorrect fuel type causes damage
to the product.
•
Use gasoline of the correct type. Refer
Technical data on page 37 . For more
to
information about the fuel, refer to the engine
manual supplied by the engine manufacturer.
•
Do a check of the fuel level before each use and
refuel if necessary.
•
Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.
14
Transportation,
Operation
Read and understand
Gasoline is very
Fuel safety on page
Always use correct fuel
•
Examine the electrical wires. Make sure that all
wires and connections are safe.
•
Make sure that the freewheel control is in
the "Transmission engaged" position. Refer to
Transportation on page 35 .
•
Make sure that the engine oil is at the correct
level.
•
Make sure that the tank is filled with the correct
type of fuel.
•
Make sure that you know the location and
function of all controls.
•
Make sure that the brake system is in safe to
operate condition.
•
Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 7 and
To do a check of the reverse operation system
(ROS) on page 8 .
•
Remove the air from the transmission before
To remove the air from the
first use. Refer to
transmission on page 30 .
To start the product
To do before you start the product
WARNING:
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
a check of the engine oil level on page 28 .
2. Fill the fuel tank with fuel. Refer to
page 14 .
3. Disengage the freewheel mode. Refer to
the product in freewheel mode on page 18 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
and disengage the parking brake on page 16 .
6. Make sure that the cutting deck is disengaged.
To engage and disengage the cutting
Refer to
deck on page 17 .
To do a check of the
Before you operate the
To do
To fill fuel on
To put
To engage
1947 - 005 - 19.10.2022
- Quick Links:
- Technical Data
Hide quick links:
Advertisement
Chapters
Table of Contents
