For the latest information, always consult the current PIONEER Service Manual. A subscription to, or additional copies Also test with plug reversed of, PIONEER Service Manual may be obtained at a (Using AC adapter Earth nominal charge from PIONEER. plug as required)
Page 3
By following the instructions in this manual, be sure to apply the prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed ones should be used. XW-HTD630...
For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) 2.1 PACKING Transmitter Wireless Speaker XW-HTD630...
Page 7
• • • • • • • • • • • • • • • • NSP 8 Polyethylene Bag Z21-038 Packing Sheet (large) AHG7010 Pad L AHA7414 Pad R AHA7415 Packing Case AHD8215 NSP 13 Warranty Card ARY7045 XW-HTD630...
E. VOL. POWER ASSY (AWU8122) POWER TRANSFORMER ATS7366 POWER CORD VDG1075 REK1110 1.6A • NOTE FOR FUSE REPLACEMENT CAUTION - FOR CONTINUED PROTECTION AGAINST RISK OF FIRE. PRI ASSY (AWU8125) B C F REPLACE WITH SAME TYPE AND RATINGS ONLY. XW-HTD630...
Page 21
: AUDIO SIGNAL ROUTE (L ch) MAIN ASSY (AWU8121) J5902 FRONT ASSY (AWU8123) RELAY ASSY LED ASSY (AWU8126) (AWU8124) Switches S5901 : SURROUND/STEREO S5902 : Ch.select : The power supply is shown with the marked box. XW-HTD630...
Page 29
Note : At this block, the assembled parts is different from the PCB silk. Assembled Silk Parts R15 ← L15 R16 ← L16 R43 ← L43 R74 ← L74 : The power supply is shown with the marked box. XW-HTD630...
Page 31
Note VTL1067 Note : At this block, the assembled parts is different from the PCB silk. Assembled Silk Parts R 8 ← L 8 R 9 ← L9 R71 ← L71 XW-HTD630...
Page 33
: The power supply is shown with the marked box. XW-HTD630...
Page 34
3.11 RX MODULE(3/4) Note Note L104 L105 VTL1067 VTL1067 Note S5688G QTL1011 470pF : The power supply is shown with the marked box. XW-HTD630...
Page 35
RX MODULE(3/4) (AXF7008) Note : At this block, the assembled parts is different from the PCB silk. Assembled Silk Parts ← L41 R104 ← L104 R105 ← L105 XW-HTD630...
V : 2V/div. H : 10µsec/div. V : 2V/div. H : 10µsec/div. U9-Pin12 U28-Pin1 V : 2V/div. H : 200nsec/div. V : 2V/div. H : 200nsec/div. U9-Pin9 U282-Pin2 V : 2V/div. H : 1µsec/div. V : 2V/div. H : 2µsec/div. XW-HTD630...
Symbol In PCB Symbol In Schematic Part Name Diagrams Diagrams C E B Capacitor Connector Transistor B C E SIDE A Transistor with resistor B C E Field effect SIDE B Chip Part P.C.Board transistor Resistor array 3-terminal regulator XW-HTD630...
VDET W119 GNDS AWU8122 CN11 POWER ASSY W110 IC13 IC12 PNE-1B1 BOND KN11 W101 4700/35 (ANP7484-B) AWU8125 POWER ASSY PNE-1B1 TRANS. PRI ASSY PRIMARY CAUTION REPLACE WITH SAME TYPE AND RATINGS OF FUSE. NEUTRAL AC IN LIVE SECONDARY (ANP7484-B) XW-HTD630...
Page 45
SIDE B SIDE B CN12 POWER ASSY VDET GNDS CN11 POWER ASSY PNE-1B1 (ANP7484-B) ASSY PRIMARY NEUTRAL PRI ASSY LIVE SECONDARY PNE-1B1 (ANP7484-B) XW-HTD630...
LED ASSY Auto Tuned D5601 R5907 R5901 CN3502 CN3051 R5902 (ANP7484-B) CN5902 CN5901 AWU8126 (ANP7484-B) FRONT ASSY AWU8123 C3055 C3056 FRONT ASSY W104 GNDD W105 MODE S5901 Channel VR3051 S5902 SURROUND STEREO PNE-1B1 (ANP7484-B) D E G D E G XW-HTD630...
Page 47
R5905 R5908 LED ASSY CN3503 CN3502 (ANP7484-B) Q5902 Q5901 (ANP7484-B) FRONT ASSY IC3051 FRONT ASSY GNDD MODE 13.VREF 12.VA+9 11.Ch.SEL 10.GNDA 9.RVIN 8.GNDA 7.LVIN 6.GNDA PNE-1B1 5.LVOUT 4.VREF 3.RVOUT 2.GNDD 1.Mode (ANP7484-B) IC3051 D E G D E G XW-HTD630...
You can diagnose the amplifier section even if the transmitter section is not available. Input audio signals to the Jumper Wire for service use indicated below. At that time remove the RX MODULE. Jumper Wire for service for signal input MAIN ASSY SIDE A W195 W194 W193 XW-HTD630...
Therefore, Q3654 maintains the OFF state. In the short or open state: The voltage appears at D3664 anode in the short state and appears at D3665 anode in the open state. Q3654 turns ON and XPROTECT becomes low (Active). XW-HTD630...
Page 62
D3461 SP PROTECT MTZJ13B C3461 C3462 Abnormal "H" 10/50 100/6.3 Solenoid When the base of Q3453 becomes "H", Q3453, Q3463 and Q3461 becomes ON, and 12V falls on the S1 solenoid. Therefore the Power Switch S1 will turn OFF. XW-HTD630...
Remove the one connector. Grille Assy Removing the hooks of the bottom plate, remove the front panel. RELAY Assy CN3502 • Rear View Remove the two screws. Remove these hooks when removing the front panel. Front Panel • Bottom View XW-HTD630...
Page 64
Hook Section • Rear View • Bottom View Remove the three screws. Antenna Remove the speaker cable from top barrier. Remove the speaker connector. Pull out the chassis section. Speaker Cable Top Barrier Speaker Connector Antenna Cover Chassis Section XW-HTD630...
Page 65
Remove the chassis section and the antenna. (See Step ø.) Remove the one connector. Remove the two push rivets. Remove the top barrier. MAIN Assy Top Barrier CN5901 RX Module Remove the two screws. Remove the RX module by removing the one connector. RX Module XW-HTD630...
Page 66
Able to input signals using the jumper wire for service. At that time remove the RX MOD ULE. (Refer to 7.1.3 DIAGNOSIS FOR AMP SECTION) AMP Module L-2CH MAIN Assy CN3305 CN3306 CN3304 CN3301 REGULATOR Assy CN3303 CN3302 Jig Cable (GGD1335) AMP Assy Diagnosis XW-HTD630...
Page 67
Pin function − − − – − – – − l a i l a i L " : " L " : " " , " L " : " – " , : " – l l u XW-HTD630...
Page 68
Low-Pass Filter Port System Clock System Clock Power Supply Zero Detect Manager Pin layout Pin function TOP VIEW − − , y l DATA − , y l LRCK DGND PCM1742 − ZEROL/NA − n i l ZEROR/ZEROA AGND XW-HTD630...
Page 70
SRAM Output External SRAM Address Bit 0 RAMDATA[0] SRAM Bidirectional External SRAM Data Bit 0 RAMDATA[1] SRAM Bidirectional External SRAM Data Bit 1 RAMDATA[2] SRAM Bidirectional External SRAM Data Bit 2 RAMDATA[3] SRAM Bidirectional External SRAM Data Bit 3 XW-HTD630...
Page 71
Input/Output SRC SCLKOUT or SRC SCLKIN signal Power 3.3 V EEPROM System Input Indicate the usage of a external serial EEPROM, 1 => serial EEPROM is present 0 => serial EEPROM is absent, use system default settings upon power XW-HTD630...
SURROUND and the main unit is set to W.Stereo. In this case, the volume 11 Antenna control has no effect, so please follow Transmits signals to the XW-HTD630 wireless these precautions. speaker. • The VOLUME knob has no effect when WIRELESS MODE is set to SURROUND.