Table of Contents
Advertisement
Overview of CPU 4168-H
1.4 More information
Restore the factory settings of the module:
You can find information on this in the documentation:
SIMATIC S7-4100, controller (Page 53)
1.4.7
Module defective
If there is a fault, send the module to your Siemens dealer for repair. Repair on site is not possible.
Repair services (https://support.industry.siemens.com/cs/ww/en/sc/2154)
If you need a replacement:
Spare part services (https://support.industry.siemens.com/cs/ww/en/sc/2110)
1.4.8
Additional support
If you have questions about the described products that are not answered in this documentation:
Please contact your Siemens representative at the agencies and branch offices responsible for
you.
You can find your contact at:
Contact partners (http://www.siemens.com/automation/partner)
The guide for technical documentation for the individual SIMATIC products and systems is
available at:
Documentation
techdoku.htm)
You can find the online catalog and online ordering system at:
Catalog (http://mall.automation.siemens.com/)
Training center
We offer the following training courses to make it easier for you to get started using the SIMATIC
automation system. Contact your regional training center or the central training center in
Nuremburg, Germany:
Training (https://www.siemens.com/sitrain)
Technical Support
You can reach the Technical Support for all Industry Automation products via the web form for
the support request
Support Request (http://www.siemens.de/automation/support-request)
You can more information on our Technical Support on the Internet at
Technical Support (http://support.automation.siemens.com).
12
(http://www.automation.siemens.com/simatic/portal/html_76/
Equipment Manual, 11/2022, A5E51584364-AA
CPU 4168-H
Advertisement
Table of Contents
