DWX723-XE/DWX724-XE MITER SAW STANDS Components List FIG. 1 A. Beam B. DW7231-XE Miter saw mounting brackets C. Extension arm D. DW7232-XE Work piece support and length stop E. Extension arm end cap F. Extension arm lock lever G. Release levers H.
CALL US AT: 1800 444 224 (Aust) or 0800 339 258 (NZ). it before putting the stand or the saw into use. Miter Saw Stand with Folding Legs DWX723-XE/DWX724-XE • DO NOT mount any power tool other than a miter saw to this stand. Mounting This stand is designed for use with most miter saws.
Page 4
Preparation (Fig. 2) FIG. 2 b. Adjust the height of the work support/stop (D) by loosening the knobs on both sides (N) and raise or lower the top surface to align with a straight edge or level 1. Place the miter saw stand on the ground with the to the saw table.
Page 5
3. Hold a mounting bracket under the saw and feed a carriage bolt (hardware bag) 4. Once the carriage bolt (hardware bag) is installed per DW7231-XE Hardware up through the bracket and the foot of the saw. Selection Chart, assemble a flat washer, lock washer and nut onto the bolt. Tighten the bolts finger tight.
Page 6
One of the mounting brackets must be engaged in the locator clip (I) by DeWalt to this miter saw stand. to prohibit lateral movement of the saw during use.
Carry Strap Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating any accessory, please If you purchase the carry strap accessory for D WALT stands, use the square hole in contact Stanley Black &...