Table of Contents
Advertisement
DOOR GLASS & GLASS SEAL REPLACEMENT
Glass and seal replacement - Refer directly to Glen Dimplex Australia Pty Ltd.
Refer to door fitment for checking of seals and glass
DOOR REMOVAL & REPLACEMENT
1. Turn off mains power to appliance.
2. Open outer door.
3. Remove door screws x 4.
4. Remove door.
5. Lift out door.
REFITTING DOOR
6. Ensure glass seal is fitted to the entire perimeter of glass.
7. Ensure door seal is sitting on glass and held in place.
8. Ensure glass is sitting firm against seal with no gaps or bows.
9. Refit door.
10. Refit brackets -Refit door screws,
Note – tighten screws hand tight – DO NOT OVERTIGHTEN OR STRIP THREADS
11. Close outer door.
GAS VALVE REMOVAL
1. Turn off mains power to appliance and isolate gas and power.
2. Open lower access.
3. Remove lower panel.
4. Turn off gas isolation valve to heater.
5. Disconnect heater from gas isolation valve.
6. Disconnect burner gas pipe from outlet of valve.
7. Disconnect sparker and flame sense lead from valve.
8. Undo 2 off nuts holding valve bracket.
9. Remove screws holding valve
10. Remove gas pipe
11. Remove valve.
13
Advertisement
Table of Contents
