Advertisement
Quick Links
ADP 4730
Programme selector knob
ON / OFF button
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Programmes
Pre-Rinse
Glasses
Quickwash
*) 5)
Eco
1) *) 5)
Normal
*) 5)
Normal
5)
Intensive
1)
Reference programme for energy label in compliance with
EN 50242 regulations;
2)
Refer to "User instructions";
3)
Program data obtained in conformity with European standard EN
50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme chart
Loading instructions
cold
Crockery to be washed later.
40°C
Light soiling, for example glasses and cups.
40°C
Lightly soiled crockery with no dried-on food.
50°C
Normally soiled crockery.
50°C
Normally soiled crockery.
65°C
Normally or heavily soiled crockery.
Recommended programme for heavily soiled
70°C
crockery, especially suitable for pans and saucepans.
Options
Time and failure display
Indicates in hours the time remaining until the
start of the wash cycle. Switches off when the
programme starts and indicates the time remaining
in hours and minutes.
"F...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after 1 -
24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
The dishwasher will start at the set time.
"Half Load" button
The half load cycle can be used for the upper and
lower rack. Select the required programme then
press the "Half Load" button. The light comes on
and goes off at the end of the programme.
The "Half Load" function can be used with
programmes marked with an *.
Antibacterial rinse
This function adds an antibacterial rinse at the end
of the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will light up when
the function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time),
the lamp will start blinking to indicate that
sanitation is not guaranteed.
Detergent
A
-
X
X
X
X
X
X
4)
The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille (France), based on the NF EN 13697 standard of
November 2001.
5)
These programmes can be used with the Antibacterial rinse
option.
(We reserve the right to make technical modifications)
GB
3)
4)
2)
3)
Consumption
B
Litres kWh
Minutes
-
5.0
0.02
10
-
13.0
0.90
55
-
13.0
0.70
30
-
13.0
1.35
90
X
16.0
1.05
120
X
16.0
1.65
100
X
17.0
1.90
135
5019 396 98068
WH/I/B/GB
Advertisement
Related Manuals for Whirlpool ADP 4730
Summary of Contents for Whirlpool ADP 4730
- Page 1 - above or below 15°C - as well as water hardness and power supply voltage, etc. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 5019 396 98068 Whirlpool is a registered trademark of Whirlpool USA...
- Page 2 How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Press the ON/OFF button. Large compartment A: With each wash cycle. How to fill the detergent dispenser Small compartment B: For programmes with pre-wash only.
- Page 3 Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): Depending on the position, for long- handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses.
- Page 4 What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem Cause Remedy The appliance is not •...