This guide addresses only those items. You should use good judgment to identify potential safety hazards due to attachment of non-Lenovo features or options not covered by this inspection guide.
4. Check for cracked or bulging batteries. 5. Remove the cover. 6. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations. 7. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.
The safety notices in this section are provided in the following languages: • English • Arabic • Brazilian Portuguese • French • German • Hebrew • Japanese • Korean • Spanish • Traditional Chinese DANGER DANGER DANGER Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
• Check for obvious damage to a hard disk drive. If the spindle of a hard disk drive becomes noisy, the hard disk drive might have been dropped or subject to excessive force. CRU list Type ac power adapter self-service Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 30
LCD cover Camera module Microphone rubber* The exploded illustrations help Lenovo service technicians identify FRUs or CRUs that they may need to replace when servicing a customer’s computer. Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Chapter 4. Removing a FRU or CRU Service tools The following table lists tools for servicing Lenovo computers. Tools with a cross mark are needed for serving the product models as described by this publication. Prepare them before you service the product.
Remove the lower case Make sure the computer has been shut down before servicing the computer. Step 1. Place the computer upside down on a flat surface. Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 37
Step 3. Pry up the latches and then remove the lower case. Figure 5. Pry up the latches and remove the lower case Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Lower case...
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable. Figure 6. Disconnect the battery pack cable Step 2. Remove four screws and then remove the battery pack. Figure 7. Remove the battery pack Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Screw specifications Number of screws M2 x 5 Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Battery pack Remove the storage drive with bracket Make sure the following FRU (or CRU) has been removed.
Page 40
Step 3. Disconnect the storage drive cable and remove the storage drive with bracket. Figure 10. Disconnect the storage drive cable and remove the storage drive with bracket Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Figure 11. Remove four screws and remove the storage drive Screw specifications Number of screws M3 x 3 Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement parts: Storage drive Storage drive bracket Remove the heat sink Make sure the following FRU (or CRU) has been removed.
Page 42
Figure 13. Loosen four screws and remove the heat sink Screw specifications Number of screws M2 x 2.5 Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Heat sink Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Remove the fan Make sure the following FRU (or CRU) has been removed. “Remove the lower case” on page 30 Step 1. Disconnect the battery pack cable from the system board. Attention: Do not pull the cable. Use your fingernail to disconnect the cable. Figure 14.
Lenovo part numbers of the following replacement parts: Remove the solid-state drive Make sure the following FRU (or CRU) has been removed. “Remove the lower case” on page 30 Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 45
Figure 18. Remove one screw and slide the solid-state drive out of the slot Screw specifications Number of screws M2 x 2.5 Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Solid-state drive Chapter 4 Removing a FRU or CRU...
Figure 20. Disconnect the coin-cell battery cable and remove the coin-cell battery Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
coin-cell battery Remove the memory module Make sure the following FRU (or CRU) has been removed. “Remove the lower case” on page 30 Step 1. Disconnect the battery pack cable. Attention: Do not pull the cable. Use your fingernail to disconnect the cable. Figure 21.
Disconnect the battery pack cable from the system board. Attention: Do not pull the cable. Use your fingernail to disconnect the cable. Figure 23. Disconnect the battery pack cable Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Lenovo part numbers of the following replacement part: Wi-Fi card Remove I/O board For Lenovo V14 Gen1 i and Lenovo V15 Gen1 i Make sure the following FRU (or CRU) has been removed. “Remove the lower case” on page 30 Step 1.
Make sure the following FRU (or CRU) has been removed. “Remove the lower case” on page 30 Step 1. Disconnect the battery pack cable, speaker cable, and the I/O board cable. Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Step 2. Remove the screw and then remove the I/O board. Figure 28. Remove the screw and then remove the I/O board Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: I/O board Remove the fingerprint reader Make sure the following FRU (or CRU) has been removed.
Lenovo part numbers of the following replacement part: Fingerprint reader Remove the system board Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 53
“Remove the heat sink” on page 35 “Remove the fan” on page 37 “Remove the solid-state drive” on page 38 “Remove the coin-cell battery” on page 40 “Remove the memory module” on page 41 “Remove the Wi-Fi card” on page 42 Step 1.
Goldern Key U1 tool. Remove the upper case (with keyboard) Make sure the following FRU ( or CRU) has been removed. “Remove the lower case” on page 30 Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 55
Step 1. Disconnect battery pack cables, EDP cable, and antenna cables. Figure 34. Disconnect battery pack cables, EDP cable, and antenna cables Step 2. Remove four screws. Figure 35. Remove four screws Screw specifications Number of screws M2.5 x 5 Chapter 4 Removing a FRU or CRU...
Page 56
Attention: When disassembling the upper case, handle the LCD module and upper case with care. Figure 37. Remove the upper case Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
“Remove the upper case (with keyboard)” on page 48 Step 1. Remove the hinge cover. Figure 38. Remove the hinge cover Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement parts: Hinge cover Remove the LCD bezel Make sure the following FRU (or CRU) has been removed.
“Remove the lower case” on page 30 “Remove the upper case (with keyboard)” on page 48 “Remove the hinge cover” on page 51 “Remove the LCD bezel” on page 51 Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 59
Step 1. Remove the removable tapes. Figure 40. Remove the removable tapes Step 2. Carefully lift the LCD panel from the LCD cover. Figure 41. Carefully lift the LCD panel from the LCD cover Chapter 4 Removing a FRU or CRU...
“Remove the lower case” on page 30 “Remove the upper case (with keyboard)” on page 48 “Remove the hinge cover” on page 51 “Remove the LCD bezel” on page 51 Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Page 61
Step 1. Remove ten screws. Figure 43. Remove 10 screws Screw specifications Number of screws M2 x 2.2 M2 x 2.5 Step 2. Carefully lift the LCD panel from the LCD cover. Figure 44. Carefully lift the LCD panel from the LCD cover Chapter 4 Removing a FRU or CRU...
“Remove the upper case (with keyboard)” on page 48 “Remove the LCD bezel” on page 51 “For Lenovo V17–IIL” on page 54 Step 1. Remove the microphone rubber. Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...
Figure 46. Remove the microphone rubber Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Microphone rubber Remove the camera module Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 “Remove the upper case (with keyboard)”...
Page 64
Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Camera module Lenovo V14 Gen1 i, Lenovo V15 Gen1 i, Lenovo V17–IIL Hardware Maintenance Manual...