Auto Pc Adjustment - Sanyo PLC-XC50 Owner's Manual
Sanyo plc-xc50: user guide
Hide thumbs
Also See for PLC-XC50:
- Service manual (116 pages) ,
- Owner's manual (81 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
Computer Input
Auto PC Adjustment
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Horizontal, and
Vertical to conform to your computer. Auto PC Adjustment function can be operated as follows.
Direct Operation
The Auto PC adjustment function can be operated directly
by pressing the AUTO SETUP button on the top control or
the AUTO SET button on the remote control.(p.46)
Menu Operation
Auto PC Adj .
1
Press the MENU button to display the On-Screen
Menu. Press the Point
frame pointer to PC Adjust Menu icon.
▲▼
2
Press the Point
pointer to Auto PC Adj. item and then press the
SELECT button twice.
To store adjustment parameters
Adjustment parameters from Auto PC Adjustment can
be memorized in this projector. Once parameters are
memorized, the setting can be done just by selecting Mode
in the PC System Menu (p.27). See "Store" on page 30.
Notes:
• Fine sync, Total dots, Horizontal, and Vertical of some
computers cannot be fully adjusted with this Auto PC
Adjustment function. When the image is not provided
properly with this operation, manual adjustments are
required. (pp.29-30)
• The Auto PC Adjustment cannot be operated when
480i, 575i, 480p, 575p, 720p,1035i, or 1080i is
selected in the PC System Menu, or when the digital
signal is input into DVI terminal. (p.27)
8
◄►
buttons to move the red
buttons to move the red frame
1
2
Remote Control
AUTO SET button
+
_
Top Control
PC Adjust Menu
PC Adjust Menu icon
Move the red frame pointer to the
Auto PC Adj. item and press the
SELECT button.
"Please wait..." message appears
while Auto PC adjustment is in
process.
AUTO SETUP
button
Advertisement
Chapters
Table of Contents
