Advertisement
Quick reference guide
PROGRAMME
START/RESUME BUTTON
SELECTION BUTTON
Push this button to start the selected programme:
Push "Programs" button
the indicator lights up and goes off at the end of the
(repeatedly) until the indicator
programme. When the door is opened during a
of the required programme
washing cycle, the cycle is temporarely paused: the
lights up (see "Table of
Start indicator blinking. To restart the cycle close
programmes" below).
the door and push Start button again.
Table of programmes
P
Programmes
1
Pre-Wash
2
Quickwash
3
2)
Eco
4
Intensive
5
Half Load
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance's automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
BUTTON
Push this button to switch on or switch off the control panel.
If pressed when a programme is running it cancels
the programme ongoing.
If the indicator flashes repeatedly, see page 5 -
chapter "What to do if ...".
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery, with no dried-
40°C
on food.
50°C
Normally soiled crockery.
Recommended programme for heavily
70°C
soiled crockery, especially suitable for
pans and saucepans.
Ideal for washing a half load of lightly or
50°C
normally soiled crockery.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
Consumption
Deter-
gent
1)
Litres kWh Minutes
—
5.0
0.02
10
X
13.0
0.70
30
X
15.0
1.05
150
X
17.0
1.65
145
X
13.0
1.00
130
ADP 2315
ANY BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
Chart
5019 396 01824
GB -1-
Advertisement
Table of Contents
Related Manuals for Whirlpool ADP 2315 WH
Summary of Contents for Whirlpool ADP 2315 WH
- Page 1 2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ...
-
Page 2: First Time Use
How to set water hardness in order to always assure the best cleaning results Water hardness should be set only before the first wash or if water hardness has been changed 1. Ask your water supply company what the water hardness is... German degrees °dH 0 - 5... -
Page 3: Daily Use
Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual indicator If required, open the cover B (press the dedicated button). Check the rinse aid indicator to check the level into the dispenser. Only use rinse aids recommended for use in domestic dishwashers. -
Page 4: How To Load The Racks
How to load UPPER RACK A - Glass-holder for long stem glasses: it can be adjusted in 2 different positions according glasses shape. B - Adjustable flaps: in horizontal position for cups/ long utensils, in raised position for plates. How to load LOWER RACK (depending on the model) F - Foldable plate holders: They can be folded down to load pots G - Fixed plate holders... -
Page 5: Select Programme
Select programme Quick, permanent or alternating Overview of programmes The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1). Choose programme according to the attached table of programmes (page 1). Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc. -
Page 6: Troubleshooting
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the courses of action, quickly restoring normal appliance operation. The appliance..is not working/not start - The appliance must be switched on. - Page 7 Crockery and cutlery..salt indicator lit - Use tablets for soft water..have deposits: regeneration salt residue - Water too hard. - Salt reservoir cap open. - Not enough rinse aid..are not dry - Plastic containers dry badly. - Clean dishes left in dishwasher for a long time after end of cycle (e.g.
-
Page 8: Precautions And General Recommendations
Disconnect the mains plug If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: 1.