Advertisement
Quick Links
Ceiling Mount
1. Remove ¼"-20 button head bolt on ceiling plate to remove lower portion of mount.
2. Install the ceiling plate with (4) 5/16" bolts to structural attachment points. Lag screws
may be used when attaching to wood joists.
3. Reattach the lower portion of the mount.
4. Attach interface plate (pn 72-1073) to projector with (5) M4 x 10 pan head Phillips
screws.
5. Align interface plate into holes on mount, slide stand off bolts into slots and tighten. Add
center locking Torx cap screw which attach secures the interface plate to the mount.
6. Attach the wire safety rope to the interface plate with the enclosed coupler.
7. Attach power and signal cables to projector.
8. Adjust left-to-right yaw. When desired position is attained, tighten ¼"-20 ring on
coupler to mount.
9. Loosen tilt adjustment cap screw with enclosed tool and level the projected image to the
screen. Tighten cap screw when a level image is achieved.
10. Loosen up-down pitch adjustment cap screw with enclosed tool and adjust the pitch
angle of the projector. Tighten cap screw when at desired projection position.
11. If desired, add Kensington lock through the opening of the mount head, loop through
cable end and attach to projector.
SEE NOTE
4X
4X
4X
2
5
6
11
3
4
9
10
8
7
12
5880 Sheridan Boulevard, Arvada, Colorado 80003
Ph: 303-412-0399 ▪ Fax: 303-412-9346
www.displaydevices.com
Advertisement
Related Manuals for NEC NP4000CM
Summary of Contents for NEC NP4000CM
- Page 1 Ceiling Mount 1. Remove ¼”-20 button head bolt on ceiling plate to remove lower portion of mount. 2. Install the ceiling plate with (4) 5/16” bolts to structural attachment points. Lag screws may be used when attaching to wood joists. 3.
- Page 2 Pole Mount 1. Install a 1 ½” NPT pipe with male threads on lower end from the ceiling. Aftermarket mounting pans and accessories are available. 2. Thread locking ring onto pipe. Thread mount (pn 72-046) onto pipe and leave locking ring loose.