Tascam FW-1082 How To Install page 2
Steinberg cubase le
Hide thumbs
Also See for FW-1082:
- Owner's manual (36 pages) ,
- Setup manual (16 pages) ,
- Application manual (4 pages)
Advertisement
Cubase LE
Windows XP Setup
1.
Do not connect the TASCAM interface yet. Install the driver for your TASCAM computer interface fi rst. In
some cases, there may be a newer version of the driver than the one on the CD that came with your unit. You
should visit www.tascam.com and select your product from the pulldown menu to make sure you have the
current version.
2.
Double-click the installer and follow the on-screen instructions, making sure your interface is disconnected
or switched off. When the installer alerts you that the device has not passed Windows logo certifi cation, click
"Continue Anyway."
3.
After restarting your computer, connect and power on your TASCAM computer interface. The FireWire or USB
LED should light up. "Found New Hardware Wizard" will appear. Make sure that "Install the software auto-
matically" is selected, then follow the on-screen instructions to install the device. Click "Continue Anyway" at
the Windows logo testing alert. You'll have to repeat this step three times, and then Windows will report that
your interface is ready to use.
4.
Insert the Cubase LE Install CD. Double-click on the installer and follow the directions. When it asks you for a
serial number, type in the letter code printed on the outside of your Cubase LE disc sleeve.
5.
Launch Cubase LE from the shortcut on your desktop or from your Start menu.
6.
When you start Cubase LE for the fi rst time, the ASIO Multimedia window will pop up and ask to test your
audio interface. Click Yes to allow the test to complete.
7.
Once Cubase LE has loaded, click on the Devices menu at the top of the screen and choose Device Setup.
8.
In the list to the left side of this window, click on VST Multitrack. Click on the ASIO Driver pulldown menu and
select your TASCAM interface from the list at 24-bit. See the diagram below.
9.
Click on All MIDI Inputs and Default MIDI Ports to make sure that Cubase LE sees your interface. If it is not
already selected as the default MIDI port, select your TASCAM interface's port 1 from the list.
10. To set your TASCAM interface as a control surface, click on the Add/Remove tab at the top of the Device Setup
window. Select Mackie Control (FW-1082, FW-1884) or US-428 (US-224, US-428) from the list and click Add.
Then, click the Setup tab and select that same device from the list on the left. For the MIDI In and Out ports,
select the Control Port for your interface. Finally, click Apply to save your changes.
11.
On the FW-1082 or FW-1884, set the TASCAM Interface/Control Surface to Cubase LE in its control panel. See
your owners manual for more information.
7733 Telegraph Rd • Montebello, CA • 90640 • 323.726.0303 www.tascam.com
© 2004 TEAC Corporation. All trademarks contained herein are the property of their respective owners. All rights
reserved. Design and specifi cations subject to change without notice.
How To Install Cubase LE with
your TASCAM Computer Interface
Advertisement
