Advertisement
Quick Links
Before using the dishwasher, read the installation and maintenance instructions carefully!
GB
ADG 9510
Programme selection button
Press the button (repeatedly) until the indicator lamp
of the desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme
selected is memorized.
Detergent setting upon initial use and when using a
different type of detergent
Indicator lamp off = Powder/gel detergent
(factory setting).
If using combined detergents, press and hold the
button for 3 seconds; the indicator lamp lights up =
rinse aid and salt indicators are deactivated.
From water hardness level 5, the salt indicator
remains active. At the end of the programme, the
most recently selected setting remains memorised.
Delayed Start button
Press the button repeatedly to delay the start of the
programme by 2, 4 or 8 hours. Then press the Start/
Resume button. The remaining time is indicated by the
corresponding indicator lamp. The wash programme
will start after the set time. The set delay will be
memorised at the end of the cycle, and can be selected
by pressing the button again.
P
Programmes
1
Pre-Rinse
2
Quickwash
2)
3
Eco
4
Intensive
5
Half Load
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary, for example,
according to different loads, extra functions, different settings, water supply temperatures, water hardness and
power supply voltage.
2)
Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
1. OVERVIEW
Table 1.1.
Table of programmes
Available
Description of programme
options
cold
Crockery to be washed later.
Lightly soiled crockery, with no
45°C
dried-on food.
Normally soiled crockery.
50°C
Energy-saving programme.
Recommended programme for
70°C
heavily soiled crockery, especially
suitable for pots and pans.
Ideal for washing a half load of lightly
50°C
or normally soiled crockery.
Start/Resume button
The indicator lamp lights up during operation, flashes when
the programme is interrupted before completion and
switches off at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to
interrupt the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this
indicates a fault: see chapter 5 "What to do if...".
Rinse aid level indicator and salt level indicator
These light up at the end of the programme if the rinse
aid or salt needs topping up. Only add just before
starting a wash cycle.
Detergent
Consumption
dispenser
large small Litres kWh
—
—
4.0
X
—
11.0
X
X
12.0
X
X
14.0
X
X
10.0
5019 396 01197
1)
Minutes
1)
0.03
14 ±
1)
0.80
30 ±
1)
1.05 165 ±
1)
1.55 155 ±
1)
1.04 145 ±
1
Advertisement
Related Manuals for Whirlpool ADG 9510
Summary of Contents for Whirlpool ADG 9510
- Page 1 Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 5019 396 01197 Whirlpool is a registered trademark of Whirlpool USA...
- Page 2 2. QUICK REFERENCE GUIDE Detailed instructions are given on the following pages; also see section “5. What to do if...”. The dishwasher switches on automatically when any button is pressed, except for the 1. Switch the button. If no button is pressed within 30 seconds, the appliance switches to Energy appliance on Saving mode.
-
Page 3: How To Use The Appliance
3. HOW TO USE THE APPLIANCE HOW TO FILL THE DETERGENT DISPENSER Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer’s recommended dosage. Observe the manufacturer’s safety warnings! Press the left button (button 1) on the dispenser to open the detergent dispenser compartments. - Page 4 3. HOW TO USE THE APPLIANCE HOW TO CHECK/FILL/ADJUST SALT Only use regeneration salt specifically intended for dishwashers. a. How to check the salt level Depending on the model, check the visual indicator . The window on the salt reservoir cap is clear when salt needs to be added and coloured when the salt present is sufficient.
- Page 5 3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on model: Adjustable glass holder A Depending on the position, for small glasses or stemware. Crockery holder B Horizontal for: cups/long utensils, in raised position for plates and stemware.
-
Page 6: Precautions And General Recommendations
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packaging The packaging materials are 100% recyclable and marked with the recycling symbol 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher has not been damaged during shipping and that the door closes correctly. - Page 7 5. WHAT TO DO IF... If a fault occurs, before contacting the After-Sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 8 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of low temperature programmes residues (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).