Table of Contents
Advertisement
The cycle time is too long or unsatisfactory dry-
1)
ing result.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 6 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
•
The set programme was incorrect.
•
The filter is clogged.
•
The condenser is clogged.
•
There was too much laundry in the appliance.
•
The drum is dirty.
•
Incorrect setting of the conductivity sensor
( See chapter "Settings - Adjustment of the
TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
Problem
Possible solution
Load is too small, increase the load or use the
Time Dry program.
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
Set the Time Dry or the Extra Dry programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
remaining laundry moisture degree " for better
setting).
•
The airflow slots are clogged.
•
Room temperature is too low or too high
( optimal room temperature 19°C to 24°C )
850 x 596 x 615 mm (maximal 647 mm)
1084 mm
945 mm
850 mm (+ 15 mm - feet regulation)
118 l
8 kg
230-240 V
2)
17
Advertisement
Table of Contents
