Advertisement
Quick Links
The OT-TB34 is an exclusive tear bar for the TM-C3400 to cut wrist band rolls from
General Data Company, Inc. (GD wristbands) manually at the perforation.
This guide explains how to install the tear bar in the TM-C3400.
Installing the OT-TB34
Follow the steps below to install the tear bar on
the paper ejection table.
1. Unlock the paper ejection guide with a
fine-tipped object.
2. Slide the paper ejection guide to as
narrow a position as possible.
3. Pull the release lever to open the roll
paper cover.
© 2012 Seiko Epson Corporation. All rights reserved.
Installation Guide
Paper ejection table
4. Insert two hooks of the tear bar into the
5. Insert the other two hooks into the
6. Make sure that the tear bar is fully
groove on the far side of the paper
ejection table.
groove on the near side.
inserted. If there is a gap between it and
the paper ejection table, press the bar
down to set it securely.
no gap
412390900
Printed in Japan
no gap
Advertisement
Related Manuals for Epson OT-TB34
Summary of Contents for Epson OT-TB34
- Page 1 Printed in Japan Installation Guide The OT-TB34 is an exclusive tear bar for the TM-C3400 to cut wrist band rolls from General Data Company, Inc. (GD wristbands) manually at the perforation. This guide explains how to install the tear bar in the TM-C3400.
- Page 2 Depending on the area, the interface cable may be included with the product. If so, use that cable. Seiko Epson Corporation shall not be held liable for any damage resulting from electromagnetic interference that occurs from the use of any interface cables other than those designated as Epson approved products.