Table of Contents
Advertisement
Quick Links
GB
ADG 7561
On button
Off button
P
Programmes
1
Pre-Rinse
2
Quickwash
2)
3
Eco
4
Daily
5
Intensive
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary according to different loads,
different extra functions, different sensor settings (for sensor programmes only), different water supply temperatures, different
water hardnesses, different power supply voltages, etc.
2)
Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for more detailed
information on the conditions of the EN comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1. OVERVIEW
Table 1.1.
Programme chart
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery, without dry
40°C
food residuals.
Normally soiled crockery. Energy
50°C
saving programme.
60°C
Normally or heavily soiled crockery.
Recommended programme for
70°C
heavily soiled crockery, particularly
suitable for pots and pans.
Programme selection button
Press the button (repeatedly) until the indicator
of the required programme lights up.
START button
The indicator lights up during operation, flashes if
a fault occurs and goes off at the end of the
programme.
START button RESET function
Press this button for at least 2 seconds and the
started programme and the extra functions
selected are cancelled. The main fault indications
(repeated flashing of the START indicator) can be
cancelled with a Reset. Also see Section 5 "What
to do, if...".
Detergent
Consumption
dispenser
large small
Litres
—
—
5.0
X
—
13.0
X
X
15.0
X
X
16.0
X
X
17.0
5019 396 01109
1)
kWh
Minutes
1)
0.02
10 ±
1)
0.70
30 ±
1)
1.05
165 ±
1)
1.35
120 ±
1)
1.65
145 ±
1
Advertisement
Table of Contents
Related Manuals for Whirlpool ADG 7561
Summary of Contents for Whirlpool ADG 7561
- Page 1 Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for more detailed information on the conditions of the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 5019 396 01109 Whirlpool is a registered trademark of Whirlpool USA...
- Page 2 2. QUICK REFERENCE GUIDE Detailed instructions are given in the following pages, see also chapter “5. What to do if...” 1. Switch on the Open the dishwasher door. appliance Press the ON button. Press the button to bring up the desired programme on the display. 2.
-
Page 3: How To Use The Appliance
3. HOW TO USE THE APPLIANCE PROGRAMME SELECTION Press the button to bring up the desired programme on the display. The appliance must be switched on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate programmes and relative available options are detailed in table 1.1 on page 1. Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. - Page 4 3. HOW TO USE THE APPLIANCE c. How to adjust the rinse aid dosage regulator The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the lever 2 to open the cover.
-
Page 5: How To Load The Racks
3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on the model Multifunction support A three possible positions for long utensils, cups and glasses. Crockery holder B in horizontal position: cups/long utensils, in raised position for plates and stemware. -
Page 6: Precautions And General Recommendations
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol. 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. - Page 7 5. WHAT TO DO IF... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 8 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of the Eco programme 50°C residues (if available), from time to time select the intensive 70°C programme (if available). The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).