Testing The Operator-Presence Switch And The E-Stop Switch - Toro RT600 Operator's Manual
Heavy duty backhoe 125 traction unit
Hide thumbs
Also See for RT600:
- Operator's manual (28 pages) ,
- Installation instructions (4 pages) ,
- Operator's manual (72 pages)
Table of Contents
Advertisement
Figure 39
1. Boom control (swing movement)
10. Move the boom to the transport position; refer to the
Transporting the Machine (page
14
Testing the Operator-Presence
Switch and the E-Stop Switch
No Parts Required
Procedure
Important: If your machine fails any of the following
tests, do not operate the machine; contact an Authorized
Service Dealer.
1. At the backhoe operator panel, perform the following
tests:
A. Stand on the walkway.
B. Move the bucket and dipper control (the leftmost
control) to the left (curl or "crowd in" the bucket)
36).
26
and then to the right (extend or "crowd out" the
bucket); refer to
Note: The bucket should not move.
C. Sit in the backhoe operator seat.
D. Move the bucket and dipper control to the left
and then to the right
Note: The bucket should curl and then extend.
E. Press the E-stop button
Note: The engine of the traction unit should
stop.
Figure 40
1. E-stop button
2. Release the engine stop switch by pulling up the E-stop
button.
3. Rotate the key switch on the machine to the Off
position.
Figure
36.
(Figure
36).
(Figure
40).
Advertisement
Table of Contents
