Table of Contents
Advertisement
Installing the Ribbon
1.
Install one of the new ribbon reels on its spindle.
Note: Use an IBM ribbon, part 4412372, or its equivalent.
2.
Loop the ribbon around the four ribbon guides
Q
and install the other ribbon
reel on its spindle.
3.
Be sure that both ribbon reels are fully seated and that there are no twists in
the ribbon.
4.
Tighten the ribbon around the ribbon guides by turning one of the reels.
5.
Close the forms feed by pulling it toward the front of the printer until it is
locked in place.
6.
Close the top cover.
Replacing the Ribbon and Ribbon Shield
4-3
Advertisement
Chapters
Table of Contents
