Hitachi Zaxis 850LC-3 Operator's Manual page 199
Hide thumbs
Also See for Zaxis 850LC-3:
- Operator's manual (477 pages) ,
- Workshop manual (28 pages) ,
- Operator's manual (20 pages)
Table of Contents
Advertisement
Unloading
WARNING: The rear end of the flatbed where it meets
the ramp is a sudden bump. Take care when traveling
over it.
IMPORTANT: Prevent possible damage to the front attach-
ment. Always position the arm at 90° to the
boom when unloading the machine. Unload-
ing the machine with the arm tucked in may
cause machine damage.
1. To move the machine over end of the trailer onto the
ramp, rest the flat surface of the tip of arm on the ground.
Angle of the arm to the boom should be 90 to 110°.
IMPORTANT: Prevent possible damage to the hydraulic
cylinders. Do not allow the machine to hit
the ground hard with the arm.
2. The tip of arm must be on the ground before the ma-
chine begins to tip forward.
3. As the machine moves forward, raise the boom and
extend the arm until the machine is completely off the
ramp.
TRANSPORTING
6-19
90 to 110°
M111-06-034
M111-06-035
Advertisement
Table of Contents
