Table of Contents
Advertisement
What to do if...?
Troubleshooting by yourself
If, during operation, the dryer shows an error display (one or more dis-
plays flashing on the programme progress display), check first of all
whether you can remedy the problem yourself by means of the table
below. If you cannot solve the problem: Switch the machine off and on
again. Reset programme. Press the START/PAUSE button.
If the error display is still shown, please contact your local Service Force
Centre and inform about flashing displays.
Problem
Dryer does not work.
Drying results unsatis-
factory.
Loading door does not
close.
20
Possible cause
Mains plug is not plugged in
or fuse is not working cor-
rectly.
Loading door is open.
Base door is open.
Have you pressed the START/
PAUSE button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at in-
stallation site differs from
standard setting of ma-
chine.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Remedy
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Close loading door.
Close base door.
Press the START/PAUSE button
again.
Select a different programme
the next time you dry
(see "Overview of pro-
grammes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended load-
ing volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Re-programme standard set-
ting for degree of drying (see
'Programming options' sec-
tion).
Install fine strainer and/or
snap large mesh filter into
place.
- Quick Links:
- Technical Data
Hide quick links:
Advertisement
Table of Contents
