Table of Contents
Advertisement
Commands
Connecting the monitor with RS-232C or connecting to a network via LAN, the control commands transmit and receive between
the monitor and a connected device. It allows for remote control of the monitor from a connected device.
Instructions for the both control command can be found in the external documents "External_Control.pdf" (See
RS-232C Interface
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY
NONE
STOP BIT
1 [bit]
FLOW CONTROL NONE
LAN Interface
PROTOCOL
PORT NUMBER
COMMUNICATION SPEED
ASCII Control command
This monitor supports control command, which is listed in the "External_Control.pdf" (See
common ASCII control command, which is used for controlling the NEC monitor or projector from a connected computer.
For further information please visit our website.
Parameter
Input command
Input signal name
HDMI1
hdmi1
HDMI2
hdmi2
DisplayPort1
DisplayPort1
DisplayPort2
DisplayPort2
OPTION*
option
COMPUTE MODULE*
compute_module
*
: This function depends on which Option Board is installed in the monitor.
1
*
: This input is available when the optional Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed.
2
TCP
7142
AUTO setting (10/100Mbps)
Response
Parameter
hdmi1 or hdmi
hdmi2
DisplayPort1
DisplayPort2
option
compute_module
Response
error:temp
error:fan
error:light
error:system
English−70
page
page
85), but also supports
Status command
Error status
Temperature abnormal
Cooling fan abnormal
Inverter or backlight abnormal
System error
85).
Advertisement
Table of Contents
