Page 1
5-055-692-31(1) AV RECEIVER Operating Instructions To cancel the demonstration (Demo) display, see page 6. To switch the FM/AM tuning step, see page 6. XAV-1600(IN) https://rd1.sony.net/help/ev/xav-1636/h_zz/ XAV-1600...
Page 2
The nameplate indicating operating voltage, etc., is suspended, or terminated without prior notice. located on the bottom of the chassis. Sony does not bear any responsibility in these sorts of situations. This product conforms to the relevant Essential Requirement of TEC, Department of...
Page 3
Important notice Caution IN NO EVENT SHALL SONY BE LIABLE FOR ANY INCIDENTAL, INDIRECT OR CONSEQUENTIAL DAMAGES OR OTHER DAMAGES INCLUDING, WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF REVENUE, LOSS OF DATA, LOSS OF USE OF THE PRODUCT OR ANY ASSOCIATED EQUIPMENT, DOWNTIME, AND PURCHASER’S TIME RELATED TO...
Screen Displays Guide to Parts and Controls Playback screen: Main Unit HOME screen: The VOL (volume) + button has a tactile dot. Display/touch screen HOME Displays the HOME screen (page 4). ATT (attenuate) Press and hold for 1 second to attenuate the sound.
Page 5
Status indication (EQ10/Subwoofer) Changes the EQ10/Subwoofer setting. Lights up when the sound is attenuated. Lights up when the Bluetooth® signal is on. Flashes when the connection is in progress. Lights up when the audio device is playable by enabling the A2DP (Advanced Audio Distribution Profile).
Basic Operations To update the firmware, visit the support site, then follow the online instructions. Switching the FM/AM Tuning URL: https://www.sony-asia.com/support Step Note During the update, do not remove the USB device. Set the FM/AM tuning step of your country.
Interface: USB (Hi-speed) Maximum current: 1.5 A Notice on license Wireless communication This product contains software that Sony uses Communication System: under a licensing agreement with the owner of its BLUETOOTH Standard version 3.0 copyright. We are obligated to announce the...
HFP (Handsfree Profile) 1.6 trademarks owned by Bluetooth SIG, Inc. and any PBAP (Phone Book Access Profile) 1.1 use of such marks by Sony Group Corporation and Corresponding codec: SBC, AAC its subsidiaries is under license. Other trademarks *1 The actual range will vary depending on factors such as...
Parts List for Installation Connection/Installation Power supply leads (1) Mounting screw (5 × max. 9 mm Cautions × max. in)) (4) • Do not install this unit in a car that has no ACC position. The display of the unit does not turn off even after turning the ignition off, and this causes battery drain.
Page 10
Connection • To prevent short circuits, insulate leads with a cover or tape. • Note that the unit may be damaged if it is connected incorrectly or by short circuits at the leads. Subwoofer* Power amplifier* Rear view camera* * from a steering wheel remote control* Smartphone, USB device...
To the parking brake switch lead *1 Not supplied *2 Speaker impedance: 4 Ω to 8 Ω × 4 The mounting position of the parking brake *3 RCA pin cord (not supplied) switch lead depends on your car. *4 Depending on the type of car, use an adaptor for the Be sure to connect the parking brake lead (light steering wheel remote control (not supplied).
Making an improper connection may damage the Notes unit. • When mounting on the dashboard, remove the visor clip URL: https://www.sony-asia.com/support carefully from the microphone , then attach the flat- • Consulting the dealer or an experienced mount base to the microphone .
Installation Mounting the unit in a Japanese car You may not be able to install this unit in some Japanese cars. In such a case, consult your Sony dealer. To the dashboard/center console Bracket Bracket Parts supplied with...