Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG FAVORIT 40260
Summary of Contents for AEG FAVORIT 40260
- Page 1 FAVORIT 40260 i Dishwasher User Instructions...
- Page 2 In the event of a malfunction, these operating instructions contain information on how to rectify faults yourself, see the "What to do, if..." section. If these instructions are insufficient, please contact your AEG Service Force Centre. In this respect please read the chapter "Service & Spare Parts".
-
Page 3: Table Of Contents
Contents CONTENTS Operating Instructions ........Safety Instructions . - Page 4 Contents Installation and Connection Instructions ....27 Installing the Dishwasher ........27 Dishwashers That Can Be Integrated .
-
Page 5: Operating Instructions
Operating Instructions OPERATING INSTRUCTIONS Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation •... - Page 6 • If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be replaced by a service engineer authorised by AEG. • Never unplug the appliance by pulling on the cable, always pull the plug.
-
Page 7: Disposal
Operating Instructions • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. -
Page 8: Appliance Features And Control Panel
Operating Instructions Appliance Features and Control Panel Rubber Seal for Connecting the Water Feed to the Upper Spray Arm Spray Arms Water Hardness Switch Container for Salt Container for Rinse Aid Container for Detergent Rating Plate Filters... -
Page 9: Control Panel
Operating Instructions Control Panel Power Indicator Light Door Handle Programme Selector Programme Switch Set the point at which the wash programme is to start using the pro- gramme switch. The programme switch rotates during the wash pro- gramme and indicates the position that has been reached in the programme. -
Page 10: Adjust The Water Softener
Operating Instructions Adjust the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 °d (German degrees) is softened with the aid of special salt. -
Page 11: Filling With Salt For The Water Softener
Operating Instructions Filling with Salt for the Water Softener Use only salt designed for dishwashers. Never fill the salt container with any another type of salt (e.g. culinary salt) or dishwasher deter- gent, as this would irreparably damage the water softener. Prior to filling with salt, please check each time that you really do have a packet of dishwasher salt in your hand. -
Page 12: Filling With Rinse Aid
Operating Instructions Depending on the size of the salt grains, it can take several hours for the salt to dissolve in the water and the green mark to become visible again. The setting of the water softener and thus the consumption of salt are dependent on the hardness of the local water. -
Page 13: Adjusting Rinse Aid Dosing
Operating Instructions 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. -
Page 14: In Daily Use
Operating Instructions In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme Loading Cutlery and Dishes Sponges, household cloths and any object that can absorb water should not be washed in the dishwasher... -
Page 15: Loading Cutlery
Operating Instructions – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long bladed knives stored in an upright position are a potential haz- ard. Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper bas- ket. -
Page 16: Loading Pans, Frying Pans And Large Plates
Operating Instructions Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1. -
Page 17: Loading Cups, Glasses And Coffee Services
Operating Instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. -
Page 18: Filling With Detergent
Operating Instructions Filling with Detergent Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. -
Page 19: Selecting The Wash Programme (Programme Table)
Operating Instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Coffee Service Type of Dishes Dinner Service and Cooking Utensils and Dessert Dishes with non- In Addition with delicate temperature glasses resistant dishes Type of Soiling... -
Page 20: Starting The Wash Programme
Operating Instructions Starting the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Close dishwasher door. 4. Turn the programme selector clockwise to A or B or C (see “Programme Table“). -
Page 21: Switching Off The Dishwasher
Operating Instructions Interrupting the wash programme by opening the door of the dish- washer Hot steam may escape when the door is opened. Open the door care- fully. 1. Open the door of the dishwasher. The wash programme stops. 2. Shut the door. The wash programme continues. Switching Off the Dishwasher When the wash programme is finished: 1. -
Page 22: Cleaning The Filter
Operating Instructions Cleaning the Filter The filters should be checked and cleaned regularly. Blocked filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove. -
Page 23: What To Do, If
The anti-flood system has tinuously - even with from the mains and contact been triggered. the appliance switched AEG Service Force. off. The door of the dishwasher is Shut the door. not closed properly. Mains plug is not plugged in. Insert mains plug. -
Page 24: The Wash Result Is Unsatisfactory
Operating Instructions ...the wash result is unsatisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were arranged in such a manner that water has not reached all parts. The dish racks must not be overloaded. –... -
Page 25: Technical Data
Operating Instructions Technical Data Capacity: 12 place settings including serving dishes Permitted Water 1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Pressure: Information on the electrical connection is given on the Electrical Connection: rating plate on the inner edge of the dishwasher door on the right. -
Page 26: Notes For Test Institutes
Operating Instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table). -
Page 27: Installation And Connection Instructions
Installation and Connection Instructions INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:... -
Page 28: Dishwashers That Can Be Integrated
Installation and Connection Instructions Dishwashers That Can Be Integrated (see installation template supplied) The door of the appliance can be fitted with a wooden/facing panel with the following dimensions: Width: 591 – 594 mm Thickness: 16 – 24 mm – Aperture height Height: dependent on –... -
Page 29: Connecting The Dishwasher
Installation and Connection Instructions Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max. -
Page 30: Water Drain
– Minimum required height 30 cm above the lower edge of the machine. Extension hoses • Extension hoses are available from AEG Service Force. The internal diameter of the extension hoses must be 19 mm to ensure that the function of the appliance is not impeded. -
Page 31: Leak Prevention System
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the drain pump switches on. By this means water can neither escape nor overflow. -
Page 32: Electrical Connection
Installation and Connection Instructions Electrical Connection Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person. WARNING - This appliance must be earthed. The manufacturer declines any responsibility should these safety measures not be observed. -
Page 33: Connections
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation. -
Page 34: Guarantee Conditions
3. Should guarantee repairs be necessary the purchaser must inform the nearest customer service office (manufacturer´s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i. e. the customer´s home, place of installation or AEG workshop). -
Page 35: Service And Spare Parts
Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Customer Care For general enquiries concerning your AEG appliance or for further information on AEG products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeghome.co.uk. - Page 36 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 946 239 - 00 - 1201 Subject to change without notice...