Advertisement
Available languages
Available languages
Quick Links
Mode d'emploi
Istruzioni per uso
English;
Page 1
Deutsch;
Seite 17
Francais;
Page 31
Italiano;
Pag. 45
STEREO CASSETTE TAPE DECK.
;
,
STEREO-KASSETTENBANDGERAT
sb
BAe led PLATINE CASSETTE STEREO
Bedienungsanlertung
REGISTRATORE A CASSETTE STEREO
CT-SssrR
e
Photograph shows BLACK finished mode}.
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/EEC.
"
Thank you for buying this Pioneer product.
Piease read these operating instructions thoroughly, so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
For the sake of convenience, these operating instructions are based
on the model HEM, and they can be used for the HB, HP, KU, KC, D
and D/G models.
The differences between the models are given below.
HEM
model:
For Europe excluding U.K. ('HEM' stamped on packing case): Power
line voltage is AC 220 volts.
HB model:
For U.K. ('HB' stamped on packing case): Power line voltage is AC
240 volts.
HP model:
For Australia ('HP' stamped on packing case): Power line voltage is
AC 240 volts.
KU and KC models:
For U.S.A. and Canada ('KU' or 'KC' stamped on packing case):
Power line voltage is AC 120 volts.
D and D/G models:
For destinations excluding above ('D' or 'D/G' stamped on packing
case): A 3-point (120 V/220 V/240 V) voltage selector switch is pro-
vided.
NOTE:
Depending upon the model,
the design of the power plug and the
power outlet differs.
The line voltage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cord into an outlet. If it is not set properly, change the setting of it
according to the LINE VOLTAGE SELECTION (D and D/G models
only).
IMPORTANT NOTICE (For KU and KC models)
The serial number for this equipment is located on the rear panel.
Ptease write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.
WARNING:
TO PREVENT
FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
LINE VOLTAGE SELECTION
(D and D/G models only)
Before your model is shipped from the factory, the switch is set to the
power
requirements
of the destination;
nevertheless,
you
should
check that it is set properly before plugging the power cord into the
AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
Screwdriver
HEM
(for
Europe
excluding
U.K.),
HB
(for U.K.),
HP
(for
Australia), KU (for U.S.A.) and KC (for Canada) models are not
provided with a LINE VOLTAGE
SELECTOR
switch.
PIONEER
S
=
=
_
=
Advertisement
