Advertisement
edium
Carefully read the installation manual before beginning.
Pay attention to danger and safety notices.
be exposed:
Carefully inspect location where air conditioner will be inst
period of time.
Handle air conditioner with care.
NOTE: DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HERE.
Preliminary instructions:
Do the following before starting to install unit. See illustrations below.
Check dimensions of your unit to determine model type:
Capacity:
Unit Height:
Unit Width:
Min. Window Opening:
Min. Window Width:
Max. Window Width:
1. Check window opening size: the mounting parts
furnished with this air conditioner are made to install in
a wooden sill double-hung window. The standard parts
are for window dimensions listed above. Open sash to
2. Check condition of window: all wood parts of window
must be in good shape and able to firmly hold the needed
3. Check your storm windows:
storm window while room air conditioner is being installed.
FIG.1
sash
inner sill
outer sill
storm window frame or
other obstruction
Installation Instructions
+ Heavy duty
READ BEFORE INSTALLING UNIT
INSTALLATION WARNINGS AND CAUTION
Heavy duty
Medium
washer head
frame
assembly
side retainer
bottom rail
seal to unit
FIG.2
outer sill
storm window frame or
other obstruction
window sash seal
long hex
head screw
top angle
long
screws and
window
long flat
head bolt
sill angle
sash
inner sill
window sill; fasten to inner
sill with two nails or screws.
frame
assembly
1
Advertisement
Table of Contents
Related Manuals for Frigidaire FRA256SV2
Summary of Contents for Frigidaire FRA256SV2
-
Page 1: Installation Instructions
Open sash to long screws and bottom rail 2. Check condition of window: all wood parts of window seal to unit must be in good shape and able to firmly hold the needed window frame assembly long flat head bolt 3. -
Page 2: Heavy Duty
5. Check the available electrical service WARNING Power supply must be the same as that shown on the unit serial nameplate. (See Use & Care Guide for serial plate location.) Power from the power cord. -
Page 3: Window Mounting
4. Insert a 7/16" locking screw and flat washer into hole on top leg of each window filler panel (see section 6). Do not totally tighten. Allow leg to slide freely. Screws will be tightened after Section 6. - Page 4 Installation Instructions “I WINDOW TAINER Place Cabinet in Window FIG.11 For wooden window: For Vinyl-Clad window: FIG.13A FIG.13B FIG.12 HEX-HEAD SCREW Install Support Bracket FIG.15B FIG.14 SCREWS FIG.15A...
- Page 5 Reconnect electronics plug if present. Position vent control lever so that it will thread into its channel in the front panel (see FIG.21). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs snap into place on cabinet.
-
Page 6: Thru-The-Wall Installation
Installation Instructions Thru-The-Wall Installation NOTE: Select Wall Location This air conditioner slides out from its cabinet, so that it can be installed through an outside wall as explained below. NOTE: IMPORTANT: Side louvers must never be blocked. All parts needed for Thru-The-Wall Installation are provided, except a wood frame, shims, and 10 wood screws... - Page 7 4. Build a wooden frame with the INSIDE dimensions of your model listed above. (Measure twice remember...) Frame depth should be the same as wall thickness. Fill in the space from the opending to the studs with wood spacers, as shown.
- Page 8 2. Secure cabinet in place using masonry nails, or the right masonry anchor screws. (Another way to secure cabinet is to build a frame in the masonry wall such as the one shown in Fig. 3 of Step 2 Prepare Wall. Securely anchor frame to 3.