TRANSPORTATION INSTRUCTIONS • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. • If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, INSTALLATION INSTRUCTIONS ensure that it is left in a safe condition to prevent the entrapment of young children.
‘Care & cleaning’ for further information. elsewhere in the house. 7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water The moulded plug on this appliance incorporates a 13 A fuse.
GETTING TO KNOW YOUR COMBI BEKO FRIDGE / FREEZER 3. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder. If installed next to a source of heat or freezer, maintain the following minimum side clearances:...
Remove upper door carefully off the upper hinge and stand door upright in a safe place.(6) Unscrew and remove the upper hinge using a flat-headed screwdriver.(7) 10. Rotate the upper hinge 180 degrees and then unscrew and remove the hinge pin using a pair of pliers and re-fit to opposite side of hinge.(8) 11.
Before you start using the fridge/freezer check that: Do not freeze too large a quantity at any one time. The quality of the food is best preserved when it is frozen right through to the core as quickly as possible.
** Make sure that no water enters the lamp housing. During defrosting water droplets may form ** If the appliance is not going to be used for a long period of time switch it off, at the back of the fridge compartment remove all food, clean it and leave the door ajar.
Prepare fresh food for freezing in small portions to ensure rapid freezing. Wrap all food in aluminium foil or freezer quality polythene bags and 4. If the light still fails to work, switch off at the socket outlet and pull out the mains make sure any air is excluded.
• Repairs required as a result of unauthorised repair or inexpert installation that fails to meet the requirements contained in the user instruction book. • The plug is inserted properly in the socket and that the power supply is on. (To • Repairs to products used on commercial or non-residential household premises.
You should also complete the details below; it will help us assist you when requesting service. (The model number is printed on the Instruction Booklet and the serial...