Table of Contents
Advertisement
Programming
the Remote €o,,ntrol (Continued) ..........
• This Remote Control is capable of learning
operating
codes from most infrared
remote control transmitters.
You can
control
the functions
of your TV and a variety
of video/audio
equipment
with the supplied
Remote Control.
• The 31 buttons
marked with • can be used as the Learning
buttons.
USE
switch
eTV
• CABLE
• VCR
• AUX
TVNIDEO
TIMER
OO
1
Set the TMICABLEIVCRIAUX
switch to the "AUX"
position.
2
Set the USE/LEARN
switch to the "LEARN"
position.
4
5
USE • • LEARN
Place the supplied
Remote Control and the remote control transmit-
ter to be learned, head to head approximately
1 to 3 inches (3 to 8
cm) apart.
(
Supplied
Remote
Control
Head to head
1-3 inches apart
f
L)O
0o®
0o®
0o®
Remote Control to
be learned
Hold down the button to learn on the supplied
Remote Control for
about 1 second until the LEARN indicator
lights up.
When you press a button other than a Learning button,
the indicator
will blink.
Hold down the button
of the function
to be learned on the other
remote control transmitter
for about 3 seconds until the LEARN
indicator
goes off.
Note:
If the LEARN indicator
blinks, the supplied
Remote Control
cannot learn the operating
code or an error has occurred.
Try steps 4 and 5 again.
6
Repeat steps 4 and 5 for storing other functions
into other buttons.
7
Set the USE/LEARN
switch to the "USE"
position,
USE • • LEARN
8
To check your programming,
operate the appropriate
equipment
with
the supplied
Remote Control.
If the equipment
does not operate as
expected,
repeat steps 1 to 7.
If needed, try changing
the distance between the two remote con-
trols.
32
Advertisement
Table of Contents
