Table of Contents
Advertisement
5.
Remove the cable from the clips (5) below the battery.
NOTE:
screw holes. The absence of or damage to these isolators can result in degraded speaker
performance.
To install the speakers, reverse this procedure.
RJ-45/audio board
To remove the RJ-45/audio board, use this procedure and illustration.
Table 5-5
RJ-45/audio board descriptions and part numbers
Descriptions
RJ-45/audio board
RJ-45/audio board cable (available in the Cable Kit)
RJ-45 door
Before removing the RJ-45/audio board, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the RJ-45/audio board:
1.
Disconnect the cable from the ZIF connector (1) on the board.
2.
Remove the three Phillips M2.0 × 1.8 screws (2) that secure the board to the computer.
When removing the speakers, make note of the location of the rubber isolators (6) in the
Bottom cover on page
Preparation for disassembly on page
27).
Battery on page
Spare part numbers
P11718-001
N99790-001
P11717-001
27).
28).
RJ-45/audio board
33
Advertisement
Table of Contents
