Table of Contents
Advertisement
11.13 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the lid lock
indicator
stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button On/Off
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
To open the appliance lid:
1. Press button Start/Pause
The lid lock indicator
2. Open the appliance lid.
3. Close the lid and press button Start/
Pause
.
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display
comes on and the lid locked
indicator
goes off.
The indicator of Start/Pause button goes off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
for some
.
goes off.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours
11.16 Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause button.
The appliance drains the water and spins.
3. When the programme is completed and
the door lock indicator
can open the door .
4. Press On/Off some seconds to deactivate
the appliance.
The appliance drains and spins
automatically after approximately18
hours.
11.17 AUTO Stand-by option
The AUTO Stand-by function automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you press Start/Pause
button.
Press the button On/Off to activate the
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On/Off to activate the
appliance again.
The display shows the end of the last set
programme.
is on. The lid stays
goes off, you
ENGLISH
23
Advertisement
Table of Contents
