hit counter script

Installation Instructions; 33.1 General Installation Instructions - Bosch HNG978Q 1 Series User Manual And Installation Instructions

Table of Contents

Advertisement

en Installation instructions
Recommended settings for cooking food using the microwave
Food
Custard
Sponge
Meat loaf
Recommended settings for cooking in combination with the microwave
Food
Potato gratin
Cakes
Chicken
Turn the dish 2/3 of the way through the cooking time.
1

Installation instructions

33  Installation instructions
Observe this information when installing the appliance.
 33.1 General installation instructions
Follow these instructions before you start in-
stalling the appliance.
¡ The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35 mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡ Ventilation slots and intake openings must
not be covered.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Do not use the door handle for the trans-
port or installation.
56
Accessory/
Height
cookware
Uncovered
2
cookware
Uncovered
2
cookware
Uncovered
2
cookware
Accessory/
Height
cookware
Uncovered
2
cookware
Uncovered
2
cookware
Pan support
2
Type of
Temperat-
heating
ure in °C
→ Page 12
-
-
-
Type of
Temperat-
heating
ure in °C
→ Page 12
170-190
180-200
200-220
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ The mains socket for the appliance must
either be located in the hatched area
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket ⁠ .
Microwave
Steam in-
power set-
tens-
ting in W
ity/"Crisp
Finish"
1. 360
-
2. 180
600
-
600
-
Microwave
Steam in-
power set-
tens-
ting in W
ity/"Crisp
Finish"
360
-
180
-
360
-
Cooking time
in mins
1. 20
2. 20-25
7-9
22-27
Cooking time
in mins
25-30
18-23
1
25-35
or

Advertisement

Table of Contents
loading

Table of Contents