Table of Contents
Advertisement
8.
DAILY USE
8.1 Start a programme without Finish
In
Before you use the appliance to dry
items:
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you close the
door, the laundry does not get caught
between the appliance door and the
rubber seal.
2. Press the "
on/off" button to activate
the appliance.
3. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
Real drying time will depend
on type of the load (quantity and
composition), the room temperature
and the humidity of your laundry after
spin drying phase.
4. Press the "
Start/Pause" touch key.
The programme starts.
18
ENGLISH
8.2 Starting the programme with
Finish In
1. Set the correct programme and
options for the type of load.
2. Press the "
Finish In (-) and (+)"
touch key.
- : Decrease finish in time.
+ : Increase finish in time.
You can delay the start of a
programme
"
Finish In (-) and (+)"
(Minimum is 1hr (depend on cycle) and
maximum is 24hr.)
3. During Finish In phase on the display
will show time (e.g. 3h, 2h or 1h).
After cycle start on the display will
show time end of programme.
8.3 Change a programme
1. Press the "
on/off" button to
deactivate appliance
2. Press the "
on/off" button to activate
the appliance.
3. Set the programme.
8.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The display shows "
• The icon "
" is on.
• The icon "
" is on.
• The
"
Start/Pause" touch key
The appliance continues to operate with
the anticrease phase for approximately
30 minutes or more if "Extra Anticrease"
option was set (see chapter Option
-"Extra Anticrease").
The anticrease phase reduces creasing.
You can remove the laundry before
the anticrease phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed.
"
is on.
Advertisement
Table of Contents
