Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. TECHNICAL DATA..................6 5.
Page 3
• Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. • Children of less than 3 years of age should be kept away from the appliance unless continuously supervised.
• Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. • Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
Page 5
• Connect the mains plug to the mains • Do not touch the glass door while a socket only at the end of the installation. programme operates. The glass can get Make sure that there is access to the hot. mains plug after the installation.
• Cut off the mains electrical cable close to • Dispose of the appliance in accordance the appliance and dispose of it. with local requirements for the disposal of • Remove the door catch to prevent children Waste Electrical and Electronic Equipment or pets from becoming trapped in the (WEEE).
Electrical connection Voltage 230 V Overall power 1600 W Fuse 10 A Frequency 50 Hz Level of protection against ingress of solid particles and moisture ensured IPX4 by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure Minimum 0.5 bar (0.05 MPa)
Page 8
Adjust the appliance correctly to prevent vibration, noise and movement of the appliance when it operates. 1. Install the appliance on a flat hard floor. The appliance must be levelled and stable. Make sure that the appliance does not touch the wall or other units and there is air circulation below the appliance.
Page 9
45º 45º 20º 20º This valve must not be assembled on appliance. Connect the valve to water inlet hose with 3/4" thread. Set the valve according 3. If necessary, loosen the ring nut to set it in to flow direction indicated by the arrow. the correct position.
Page 10
• To a stand pipe with vent hole - insert the drain hose directly into a drain pipe or stand pipe. Make sure that the plastic guide cannot • The drain hose can be bent into U shape move when the appliance drains and the and put around the plastic guide.
Connect the appliance to an earthed The power supply cable must be easily socket. accessible after installing the appliance. For any electrical work required to install this appliance, contact our Authorised Service Centre. The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.
Page 12
• No Spin 0 you press button Start/Pause. The relevant Set this option to deactivate all spin light will light up. phases. The appliance performs the only • Kurz draining phase of the selected washing Short programme for lightly soiled white-/ programme.
7.10 Indicators The light Spülen illuminates when appliance is performing the rinsing phase of the washing cycle. The light Schleudern illuminates when appliance is performing the spinning phase of the washing cycle. The light Ende indicates if the door can be opened: •...
Page 14
Programme Spin speed Maxi‐ Programme description Temperature range (Type of load and level of soiling) range load 3 kg To drain the water in the drum. All fabrics. Abpumpen 1300 rpm 3 kg All fabrics, except woollens and delicate fabrics. To spin Schleudern the laundry and to drain the water in the drum.
Suitable detergents for washing programmes Programme Universal Liquid Univer‐ Liquid for col‐ Delicates Special oureds woollens powder 1) Eco 40-60 ▲ ▲ ▲ Kochwäsche/Bunt‐ ▲ ▲ ▲ wäsche ▲ ▲ ▲ Pflegeleicht ▲ ▲ Feinwäsche ▲ ▲ Wolle ▲ ▲ At temperature higher than 60 °C the use of powder detergent is recommended.
Page 16
2. Put the detergent and the fabric CAUTION! conditioner into the proper compartments. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. Always follow the instructions that you find on the packaging of the detergent CAUTION! products, but we recommend that you do...
Page 17
10.7 Cancelling a programme appliance starts operating and the door is locked. Turn the selector dial to position to cancel 10.5 Starting a programme with the a programme which is running. Now you can delay start select a new programme. To set delay the start option press the button 10.8 Opening the door after the Zeitvorwahl repeatedly, to select the desired...
When the pilot light Ende goes out, the door do not intend to carry out another wash, close can be opened and the laundry can be the water tap. removed. Leave the door open to prevent the formation At the end of the cycle, turn the programme of mildew and unpleasant smells.
11.4 Ecological hints • Use only detergents and other treatments specially made for washing machines. To save water, energy and to help protect the First, follow these generic rules: environment, we recommend that you follow – powder detergents for all types of these tips: fabric, excluding delicate.
Page 20
Indicative periodic cleaning schedule: Regularly examine the drum to prevent limescale and rust particles. Descaling Twice a year To remove rust particles use only special Maintenance wash Once a month products for washing machines. Do this separately from the laundry wash. Clean door seal Every two months Clean drum...
Page 21
3. Put the siphon back into position by pressing it downwards until you hear a click. Always follow the instructions that you 4. Use a small brush to clean the recess. find on the packaging of the product. Make sure that all detergent residue is Do not clean the drum with acidic removed from the upper and lower part of descaling products, scouring products...
12.10 The dangers of freezing If the appliance is installed in an area where the temperature can reach values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. • Close the water tap and unscrew the inlet hose from it.
Page 23
With some problems indicator of the END of WARNING! programme blinks: Deactivate the appliance before carrying out any check. Problem Possible cause/Solution 1 flash • Make sure that the water tap is open. The appliance does not fill • Make sure that the pressure of the water supply is not too low. For this informa‐ with water properly.
Page 24
Problem Possible cause/Solution You cannot open the appli‐ • Make sure that a washing programme that ends with water in tub, has not ance door. been selected. • Set the drain or the spin programme if there is water in the drum. •...
14. CONSUMPTION VALUES 14.1 Introduction See the web link www.theenergylabel.eu for detailed information about Energy Label. The QR code on the energy label supplied with the appliance provides a web link to the information related to the performance of the appliance in the EU EPREL database. Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.10 1.00 4.00 Time to Off/Standby mode is 15 minutes maximum. 14.4 Common programmes These values are indicative only. Programme rpm 1) Litres hh:mm °C Kochwäsche/Buntwä‐ 1.30 50.0 2:20 53.00 85.0...