Page 2
Please read this manual before using the product! Dear Customer, We'd like you to make the best use of our product, which has been manufactured in modern facilities with care and meticulous quality controls. Thus, we advice you to read the entire user manual before you use the product. In case the product changes hands, do not forget to hand the guide to its new owner along with the product.
Page 3
Table of Contents 1 Safety and Environment Instructions 3 4 Preparation 1.1. General Safety ..... . 3 4.1. What to do for energy saving ... 16 1.1.1 HC Warning.
Page 4
Safety and Environment Instructions – catering and similar non-retail This section provides the safety applications. instructions necessary to prevent the risk of injury and material damage. Failure to 1.1. General Safety observe these instructions will invalidate This product should not be used by •...
Page 5
Safety and environment instructions Do not use steam or steamed cleaning Do not step or lean on the door, • • materials for cleaning the refrigerator drawers and similar parts of the and melting the ice inside. Steam may refrigerator. This will cause the product contact the electrified areas and cause to fall down and cause damage to the short circuit or electric shock!
Page 6
Safety and environment instructions Do not install on the hot water inlet. This product has been manufactured • with high quality parts and materials Take precautions against of the which can be reused and are suitable risk of freezing of the hoses. Water for recycling.
Page 8
Refrigerator *Optional: Figures in this user guide are schematic and may not be exactly match your product. If your product does not comprise the relevant parts, the information pertains to other models. Refrigerator / User Guide 7 / 41 EN...
Page 9
Installation 3.1. Right place for installation 3.2. Attaching the plastic wedges Use the plastic wedges in the provided with Contact the Authorized Service for the product's the product to provide sufficient space for air installation. To ready the product for installation, circulation between the product and the wall.
Page 10
Installation 3.3. Adjusting the stands In order to adjust the doors vertically, If the product is not in balanced position, adjust the •Loosen the fixing nut at the bottom front adjustable stands by rotating right or left. •Screw adjusting nut (CW/CCW) according to the position of the door •Tighten the fixing nut for the final position In order to adjust the doors horizontally, • Loosen the fixing bolt on the top • Screw the adjusting bolt (CW/CCW) on the side according to the position of the door...
Page 11
Installation 3.5. Water connection (Optional) WARNING: Unplug the product and the water pump (if available) during connection. The product’s water mains, filter and carboy connections must be rendered by authorizer service. The product can be connected to a carboy or directly to the water mains, depending on the model.
Page 12
Installation 3.6. Connecting water 3.7. Connecting to water mains hose to the product (Optional) To connect the water hose to the product, To use the product by connecting to the cold water follow the instructions below. mains, a standard 1/2” valve connector must be 1.
Page 13
Installation 4. Attach the connector into the faucet adaptor 2. Connect the other end of the water hose to and tighten by hand / tool. the water pump by pushing the hose into the pump’s hose inlet. 5. To avoid damaging, shifting or accidentally 3.
Page 14
Installation 3.9.1.Fixing external filter on the wall (Optional) WARNING: Do not fix the filter on the product. Check to see the following parts are supplied with your product’s model: 4. Attach the water hose extending from the top of the filter to the product’s water connection adaptor, (see 3.6.) 1.
Page 15
Installation 3.9.2.Internal filter 1. “Ice Off” indicator must be active while installing the filter. Switch the ON-OFF The internal filter provided with the product is not indicator using the “Ice” button on the screen. installed upon delivery; please follow the instructions below to install the filter.
Page 16
Installation 3. Remove the water filter by-pass cover by pulling. A few drops of water may flow out after removing the cover; this is normal. 4. Place the water filter cover into the mechanism and push to lock in place. 5.
Page 17
Preparation 4.1. What to do for energy saving 4.2. First Use mehmet Before using your refrigerator, make sure the Connecting the product to electronic necessary preparations are made in line with energy-saving systems is harmful, as it the instructions in “Safety and environment may damage the product.
Page 18
Using the product 5.1. Indicator panel Indicator panels may vary depending on the model of your product. Audial and visual functions of the indicator panel will assist in using the refrigerator. 1. Cooler compartment indicator 2. Error status indicator 3. Temperature indicator 4.
Page 19
Using the product 1. Cooler compartment indicator Push the Vacation button ( ) again to cancel The cooler compartment light will turn on when this function. adjusting the cooler compartment temperature. 5. Temperature adjustment button 2. Error status indicator Respective compartment's temperature varies in This sensor will activate if the refrigerator is not -24°C..
Page 20
Using the product Eco Mode interaction with product/ Display On after any interaction with buttons Yellow: Vacation 1- Power failure/High temperature / error warning 2- Freezer compartment temperature setting 3- Quick freeze 4- Key lock 5- Vacation function 6- Quick Fridge 7- Fridge compartment temperature setting 8- Eco fuzzy 9- Alarm off warning...
Page 21
Using the product indicator displays -27. To cancel this function press the quick freeze button ( ) again. Quick • High temperature alarm :RED (1 Hz flash) freeze indicator will turn off and refrigerator will • Within 1 min. after the door is opened reset to its normal settings.
Page 22
Using the product 8. Eco fuzzy Press and hold the eco fuzzy button for 1 seconds to activate the eco fuzzy function. Refrigerator will start operating in the most economic mode at least 6 hours later and the economic usage indicator will be on ( ).
Page 23
Using the product 7.1 7.2 1. Economic use 2- High temperature / fault alert 3. Energy saving function (display off) 4- Rapid cooling 5- Vacation function 6- Cooler compartment temperature setting 7. Energy saving (display off) /Alarm off 8- Keypad lock 9- Eco-fuzzy 10- Freezer compartment temperature setting 11- Rapid freezing...
Page 24
Using the product 1. Economic use cool a large amount of fresh food, press the rapid This sign will light up when the freezer cool button before placing the food in the cooler compartment is set to -18°C', the most compartment.
Page 25
Using the product the keypad lock mode will be disengaged. Press the Display off button to prevent changingthe refrigerator’s tempeture settings. 9. Eco-fuzzy To activate the eco-fuzzy function, press and hold the eco-fuzzy button for 1 second. When this function is active, the freezer will switch to the economic mode after at least 6 hours and the economic use indicator will light up.
Page 26
7.1 7.2 Using the product 11.2 11.1 1. Freezer compartment temperature setting 2. Economy mode 3. Energy saving function (display off) 4. Power failure/High temperature / error warning indicator 5. Cooler compartment temperature setting 6. Rapid cooling 7. Vacation function 8.
Page 27
Using the product 1. Freezer compartment temperature setting 6. Rapid cooling For rapid cooling , press the button; this will Pressing the button ( ) will enable the freezer compartment temperature to be set at -18,-19,- activate the rapid cooling indicator ( 20,-21 ,-22,-23,-24,-18...
Page 28
Using the product display will go off and the display will enter the energy saving mode. When you press the Display off button again and when the( ) function is lit, all the other icons of the display will be lit and the display will exit the energy saving mode.
Page 29
Using the product 5.2. Activating water filter change warning (For products connected to the mains water line and equipped with filter) Water filter change warning is activated as follows: Automatic filter usage time calculation is not enabled ex factory. It must be enabled in products equipped with a filter. The S4 display board we use in the refrigerator has a nine-key system.
Page 30
Using the product Press twice Press once Refrigerator / User Guide 29 / 41 EN...
Page 31
Using the product 5.4. Using the water fountain 5.3. Humidity controlled crisper (for certain models) (FreSHelf) (This feature is optional) Humidity rates of the vegetables and fruit are The first few glasses of water taken from kept under control with the feature of humidity- the fountain will normally be warm.
Page 32
Using the product 5.6. Cleaning the water tank Remove the water filling reservoir inside the door shelf. Detach by holding both sides of the door shelf. Hold both sides of the water tank and remove at 45° angle. Remove and clean the water tank lid. Do not fill the water tank with fruit juice, fizzy beverages, alcoholic beverages or any other liquids incompatible for use in...
Page 33
Using the product 5.7. Taking ice / water • The water may be cloudy during first use of the filter; do not consume the first 10 glasses (Optional) of water. To take water ( ) / ice cube ( ) / fragmented • You must wait approximately 12 hours to get ice ( ), use the display to select the respective...
Page 34
Using the product 5.9. Zero degree compartment 5.12. Ionizer (Optional) (Optional) Use this compartment to keep delicatessen The ionizer system in the cooler compartment's at lower temperatures or meat products for air duct serves to ionize the air. The negative immediate consumption.
Page 35
Using the product 5.16. Ice-maker 5.15. Icematic and ice storage box (Optional) (Optional) Ice maker is located on the upper section of the Fill the icematic with water and put in place. freezer cover. The ice will be ready after approximately two hours.
Page 36
Using the product When the ice dispenser does not work properly If you do not remove ice cubes for a long time, they will cause formation of ice chunks. In this case, please remove the ice stock reservoir in accordance with the ...
Page 37
Using the product 5.17. Freezing fresh food 5.18. Recommendations for storing frozen foods • To preserve food quality, the food items placed in the freezer compartment must be frozen as The compartment must be set to at least -18°C. quickly as possible, use the rapid freezing for 1.
Page 38
Using the product The lamp(s) used in this appliance is not suitable 5.20. Placing the food for household room illumination. The intended Freezer Various frozen goods including purpose of this lamp is to assist the user to place compartment meat, fish, ice cream, foodstuffs in the refrigerator/freezer in a safe and shelves vegetables etc.
Page 39
Maintenance and cleaning Cleaning your fridge at regular intervals will ex- • Check regularly that the door gaskets tend the service life of the product. are clean. If not, clean them. • To remove door and body shelves, remove all of its contents. • Remove the door shelves by pulling WARNING: them up.
Page 40
Troubleshooting The power is out. >>> The product will Check this list before contacting the service. • Doing so will save you time and money. This list continue to operate normally once the includes frequent complaints that are not related to power is restored.
Page 41
Troubleshooting The freezer temperature is very low, but the Shaking or noise. cooler temperature is adequate. The ground is not level or durable. >>> If • The freezer compartment temperature is set • the product is shaking when moved slowly, to a very low degree.
Page 42
Troubleshooting The foods were placed in unsealed holders. • >>> Keep the foods in sealed holders. Micro-organisms may spread out of unsealed food items and cause malodour. Remove any expired or spoilt foods from the product. The door is not closing. Food packages may be blocking the door.