Getting to Know HUAWEI Mobile WiFi Connection Scenarios A Wi-Fi device or computer can be connected to the Internet through the Mobile WiFi. The actual connection procedure depends on the operating system of the Wi-Fi device or computer. The connection scenarios illustrated here are for your reference.
Page 3
Scenario 3: Multi-device access via Wi-Fi and USB at the same time Game machine Smart phone Digital camera Laptop...
Page 4
Appearance Item Screen WPS button Power button USB port microSD card slot Battery button Strap hole...
Page 5
Screen Item Signal strength Network Wi-Fi enabled Number of devices connected Internet connection status New messages Number of new messages 0B 00:00 Battery level International roaming state Traffic data Connection duration ...
Page 6
Note: Wi-Fi: Wireless fidelity WPS: Wi-Fi protected setup Traffic statistics are for your reference only. To obtain the actual traffic data, contact your service provider.
Before You Start Installing the SIM Card and the Battery Caution: Do not use any SIM card that is not standard or is incompatible with the Mobile WiFi. Otherwise, the Mobile WiFi may be damaged. Insert the SIM card in the card slot. Be sure that the SIM card is facing in the right direction, as shown in figure 2, and then slide the SIM card into the slot.
Installing the microSD Card Remove the rubber cap from the microSD card slot. Then insert the microSD card into the slot. After inserting the microSD card completely, attach the rubber cap. Note: The microSD card is an optional accessory. If a microSD card did not come with your ...
Page 9
Method 1: Using the charge Caution: Only use chargers compatible with the Mobile WiFi and provided by a designated manufacturer. Use of an incompatible charger or one from an unknown manufacturer may cause the Mobile WiFi to malfunction, fail, or could even cause a fire. Such use voids all warranties, whether expressed or implied, on the product.
Accessing the Internet via Wi-Fi Connection Note: By default, management parameters are preset on the Mobile WiFi according to the requirements of the service provider. Follow the steps below to quickly access the Internet. For the details about how to set management parameters, see help on the web management page.
Page 11
Select Start > Control Panel > Network Connections > Wireless Network Connection. Note: To set up a Wi-Fi connection, the PC must have a wireless network adapter installed. If Wireless Network Connection is displayed, a wireless network adapter is available. Otherwise, check to make sure you have a wireless network adapter installed.
Step3: Access the Internet After you establish a Wi-Fi connection successfully, you can access the Internet using the following modes. Caution: Please select a proper Internet connection mode based on your service expense. For example, if you are subscribed to the time-based network service, you are recommended to select Manual mode.
Note: Launch the web management page to select the mode for accessing the Internet. You can choose whether to enable the Mobile WiFi to connect to the Internet automatically even while you are roaming. If this function is disabled, the Mobile WiFi automatically disconnects from the Internet while you are roaming.
Daily Use Power Saving Mode If no operation is performed on the Mobile WiFi within a preset period, the screen turns off. Press any key to light up the screen. If the Mobile WiFi is powered by the battery only, choose whether to enable the Mobile WiFi to turn off Wi-Fi automatically.
Establishing a WPS Connection If a Wi-Fi client connected to the Mobile WiFi supports the WPS function, a network key will be automatically generated without manual input. To establish a WPS connection, perform the following steps: Power on the Mobile WiFi. Start the client.
Restoring Factory Defaults If you forget the changes you have made to some parameters, you may restore factory defaults and reconfigure the Mobile WiFi. To restore the factory defaults, press and hold the RESET button until the screen turns off. All factory default settings are successfully restored.
Page 17
Example 1: Wi-Fi Connection to Game Machine (Sony PSP) Turn on the PSP WLAN switch. Select Settings > Network Settings. Select Infrastructure Mode to connect to your local Wi-Fi access point. Select New Connection to specify an easy to remember connection name. Select Scan to detect all networks within range.
Page 18
WEP: The Wi-Fi key of the Mobile WiFi. The default SSID and key label are affixed to the Mobile WiFi. Press the ► button of your game machine to continue, and then press the X button to save the settings. Select Test Connection to check the connection.
Example 2: Wi-Fi Connection to a Smart Phone (iPhone) Select Settings > Wi-Fi, and then turn on Wi-Fi. Automatically detect the networks in range and display the access point list. Select a network indicated by the SSID of the Mobile WiFi. If necessary, enter a password and tap Join.
Tips If the Mobile WiFi is placed in an environment with poor ventilation, it may overheat after extended use. When the Mobile WiFi overheats, it will switch off and disconnect from the network automatically to protect itself. If this happens, place the Mobile WiFi in a well-ventilated location, then restart the Mobile WiFi.