Table of Contents
Advertisement
Available languages
Available languages
Section
04
Initial Settings
2
Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put) can be used for full-range speaker (FULL)
or subwoofer (SUB W) connection. If you
switch the rear output setting to SUB W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (FULL).
1
Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3
Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
SUB W (subwoofer)—FULL (full-range speak-
er)
# When no subwoofer is connected to the rear
output, select FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer SUB W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
25).
! If you change this setting, subwoofer output
in the audio menu return to the factory
settings.
28
En
Setting the internal power
amplifier
This unit features high power amplifier. How-
ever, in particular system, external amplifiers
are used instead of internal amplifier. If you
use external amplifiers in order to establish a
multi-amp system, and don't use internal am-
plifier, it is recommended to turn off the inter-
nal amplifier. Turning off internal amplifier
reduces the noise that comes from the beha-
vior of internal amplifier and fan.
1
Use MULTI-CONTROL to select
BUILT-IN AMP.
2
Press MULTI-CONTROL to turn the inter-
nal power amplifier on.
# To turn the internal power amplifier off, press
MULTI-CONTROL again.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1
Use MULTI-CONTROL to select
DEMO MODE.
2
Press MULTI-CONTROL to turn the fea-
ture demo on.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demo by
pressing DISP while this unit is turned off. For
more details, see About the demo mode on
page 8.
Hide quick links:
Advertisement
Chapters
Table of Contents
