2WARNING • If you have difficulty in installing this unit in your To prevent injury or fire, take the following vehicle, contact your Kenwood dealer. precautions: • If it doesn’t seem to be working properly, first press • To prevent a short circuit, never put or leave any the Reset button.
About CDs Handling CDs CDs that can’t be used • Don’t touch the recording surface of the CD. • CDs that aren’t round can’t be used. • CDs with coloring on the recording surface or that • CD-R and CD-RW are easier to damage than a normal are dirty can’t be used.
Notes on playing MP3/WMA Note, however, that the MP3/WMA recording media Entering ID3 tag and formats acceptable are limited. When writing MP3/ The Displayable ID3 tag is ID3 version 1.x. WMA, pay attention to the following restrictions. For the character code, refer to the List of Codes. Acceptable media The MP3/WMA recording media acceptable to this unit are CD-ROM, CD-R, and CD-RW.
Page 5
MP3/WMA playing order When selected for play, Folder Search, or for File When a File Search is executed with file ¡$ being Search, files and folders are accessed in the order in played ... which they were written by the CD writer. Operation of the Because of this, the order in which they are expected (Current file:...
Loading compact discs Projection Make sure the disc magazine is the right way up Insert the magazine into the CD changer until it with the "disc" logo on the top. Pull the tray out by clicks. the projection. Tray Close the CD changer door. •...
Page 8
Operations Fast Forwarding and Reversing • Some functions are disabled depending on control units to be connected. For the operation method refer to Instruction • With some video CD’s, the track number may differ Manual of Control unit. from the jacket display, or may differ from the track number display on the menu screen.
Function of MP3/WMA Function of VCD Folder Search Audio output select Selecting the folder you want to listen to. You can switch the audio output to STEREO, Left or Right. Enter Folder Search mode Press the [SCAN]/[SCN] button. Press the [38] button. Setting The stereo sound is output.
Installation Accessories A × 1 B × 4 C × 4 D × 1 F × 1 G × 1 E × 1 H × 1 Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit.
Use the holes marked to install the unit. • Do not tighten the screw B too securely at the time of installation, but tighten it securely after having fixed the bracket A. Horizontal installation Angle adjustment switch position Ø4 English...
Vertical installation Angle adjustment switch position Ø4 English...
Page 13
Connections D Changer control cable (5m) Control unit (optional) F Harness ties Fix the harness tie close to its connector. Monitor unit (optional) � � To parking brake detection switch harness of car E Video cable (Black) (4m)/ Parking senser cable (Green) (6m) ���...
Troubleshooting Guide What might seem to be a malfunction in your unit The songs in the selected folder aren’t played in may just be the result of slight misoperation or Folder Search mode. There are no MP3/WMA in the selected folder. miswiring.
Page 24
安裝 附件 A × 1 B × 4 C × 4 D × 1 F × 1 G × 1 E × 1 H × 1 拆下運輸用螺釘 在開始安裝主機前,將為了保護內部機械而裝有的 3 根運輸 用螺釘全部拆下。 •�拆下運輸用螺釘之後,須保存好該螺釘,以便再一次運輸時重新安 裝在主機上。 運輸用螺釘 角度調整開關 � •� 位於兩側面的角度調整開關要根據 CD 自動 換片器的安裝角度進行設定。兩個開關都要...
Page 25
安裝時,應使用●印孔。 •�安裝時請勿將螺釘 B 牢固旋緊,但在固定托架 A 之後應充分旋緊。 水平安裝 角度調整開關的位置 Ø4 中文(繁體字) |...
Page 38
安装 附件 A × 1 B × 4 C × 4 D × 1 F × 1 G × 1 E × 1 H × 1 拆下运输用螺钉 在开始安装主机前,将为了保护内部机械而装有的 3 根运输 用螺钉全部拆下。 ・�拆下运输用螺钉之后,须保存好该螺钉,以便再一次运输时重新安 装在主机上。 运输用螺钉 角度调整开关 � ・�位于两侧面的角度调整开关要根据 CD 自动 换片器的安装角度进行设定。两个开关都要 右面...
Page 39
安装时,应使用●印孔。 ・�安装时请勿将螺钉 B 牢固旋紧,但在固定托架 A 之后应充分旋紧。 水平安装 角度调整开关的位置 直径 4 中文 ( 简体字 ) |...