Installation; Preparation; Marking The Installation Holes - HP D7171A - NetServer - LPr Installation Manual

Compaq 4000/7000 racks installation guide

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

3 Installation

This section contains detailed instructions for installing an HP NetServer LPr in

certain models of Compaq rack enclosures.

Before beginning the installation of the NetServer into the rack, you must prepare

the rack and the NetServer.

Determine the location at which the NetServer is to be installed in the rack

enclosure. Mark the bottom and top of this location on the rack columns. The

HP NetServer LPr measures 2 EIA units tall.

First mark one hole on each of the four columns to use for the rack nuts and screws

that hold the rail to the column. Then mark two holes on each of the front columns

only to use for securing the NetServer to the rack enclosure.

When marking the holes, mark the outer surface of the column (see

Figure 3-1); on the front columns, this is the column surface facing forward; on

the rear columns, this is the surface facing rearward. Use tape or a marker pen to

mark the appropriate holes on each column.

A rack template which is marked with the appropriate holes is provided with this

NetServer. You may use this rack template to show you where to mark the holes

on the rack columns, or if you do not wish to use the template, you can simply

mark the appropriate holes as indicated in Figure 3-1.

To mark the rail mounting holes (refer to Figure 3-1), on each columns, count up

from the top of the unit below marking the third hole.

Installation

Table of Contents