Table of Contents
Advertisement
Adjusting the worktop
You can move the worktop forward or backward by 25
mm in order to align the machine with other kitchen
units.
Simply unscrew the two front retaining screws, move
the top to the required position and then retighten the
screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine's worktop, you can install it
under a close fitting sink unit or a pre-existing top,
providing the dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
- Remove the machine's worktop by unscrewing the
two front retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling
with the adjustable feet. When inserting the machine,
ensure that the water inlet and drain hoses are not
kinked or squashed.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the
cabinet.
If the door does not close correctly, loosen or tighten
the adjustable feet until the machine is perfectly level.
Fitting a decor panel on the door
The door of this machine has frames for fitting a
plastic laminate decor panel in the colour required to
match the dishwasher with the rest of the kitchen
furniture.
If you wish to do this you must provide the panel
yourself, that must have the following dimensions:
Width:
436 mm
Height:
592 mm
Max thickness:
4 mm
To fit the panel
- Take the door frame off after removing the retaining
screws around the edge.
- Position the panel, refit the frame and tighten the
retaining screws around the edge.
Note:
The panel should be fitted before
positioning the machine.
IN02
IN04
IN11
AP02
23
IN12
INS41UKen
Advertisement
Table of Contents
