Page 58
P5WD2-E PREMIUM Internal Audio Connector AAFP PORT2 L SENSE2_RETUR Line out_L ® SENSE_SEND SENSE1_RETUR PORT2 R Line out_R PRESENCE# PORT1 R MICPWR PORT1 L MIC2 AGND AC 97 audio pin definition P5WD2-E PREMIUM Analog Front Panel Connector • • 2-32...
Page 75
A:\>afudos /oOLDBIOS1.rom AMI Firmware Update Utility - Version 1.19 (ASUS V2.07(03.11.24BB)) Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading flash ..done Write to file ..ok A:\> A:\>afudos /iP5WD2EP.rom...
Page 76
A:\>afudos /iP5WD2EP.ROM AMI Firmware Update Utility - Version 1.19 (ASUS V2.07(03.11.24BB)) Copyright (C) 2002 American Megatrends, Inc. All rights reserved. WARNING!! Do not turn off power during flash BIOS Reading file ..done Reading flash ..done Advance Check ..
Page 77
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy found! Reading file “P5WD2EP.ROM”. Completed. Start flashing...
Page 78
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy not found! Checking for CD-ROM... CD-ROM found. Reading file “P5WD2EP.ROM”. Completed. Start flashing...
Page 84
[1.44M, 3.5 in] Language [English] Use [+] or [-] to configure system. Primary IDE Master [ST320413A] Primary IDE Slave [ASUS CD-S520/A] Third IDE Master [Not Detected] Third IDE Slave [Not Detected] Fourth IDE Master [Not Detected] Fourth IDE Slave [Not Detected]...
Page 85
Legacy Diskette A [1.44M, 3.5 in] Language [English] select a field. Primary IDE Master [ST320413A] Use [+] or [-] Primary IDE Slave [ASUS CD-S520/A] to configure Third IDE Master [Not Detected] Third IDE Slave [Not Detected] Fourth IDE Master [Not Detected]...
Page 86
[1.44M, 3.5 in] Language [English] Use [+] or [-] to configure system. Primary IDE Master [ST320413A] Primary IDE Slave [ASUS CD-S520/A] Third IDE Master [Not Detected] Third IDE Slave [Not Detected] Fourth IDE Master [Not Detected] Fourth IDE Slave [Not Detected]...
Page 87
Primary IDE Master Device : Hard Disk Vendor : ST320413A Size : 20.0GB LBA Mode : Supported Block Mode : 16 Sectors PIO Mode : Supported Async DMA : MultiWord DMA-2 Ultra DMA : Ultra DMA-5 SMART Monitoring: Supported Type [Auto] LBA/Large Mode [Auto]...
Page 88
IDE Configuration When in AHCI/RAID mode SATA Configure SATA As [Standard IDE] controller is Onboard IDE Operate Mode [Enhanced Mode] forced to Native Enhanced Mode Support On [S-ATA] mode. IDE Detect Time Out (Sec) [35] ® 4-16...
Page 90
AMIBIOS Version : 0107 Build Date : 11/22/05 Processor Type : Genuine Intel(R) CPU 3.80GHz Speed : 3800 MHz Count System Memory Size : 256MB Appropriated : 0MB Available : 256MB 4-18...
Page 91
Adjust system JumperFree Configuration frequency/voltage. LAN Cable Status USB Configuration CPU Configuration Chipset Onboard Devices Configuration PCIPnP Configure System Frequency/Voltage Select the targe CPU frequency, and the AI Overclocking [Auto] relevant parameters will be auto-adjusted. Performance Mode [Auto] Frequencies higher than CPU manufacturer recommends are not AI CPU Lock Free...
Page 95
POST Check LAN Cable [Disabled] Check LAN cable during POST. LAN Cable Status Pair Status Length Normal Normal Normal Normal Open 0.0M Open 0.0M Open 0.0M Open 0.0M 4-23...
Enables USB host USB Configuration controllers. Module Version - 2.24.0-F.4 USB Devices Enabled: None USB Function [Enabled] Legacy USB Support [Auto] USB 2.0 Controller [Enabled] USB 2.0 Controller Mode [HiSpeed] BIOS EHCI Hand-off [Disabled] USB Mass Storage Device Configuration USB Mass Storage Reset Delay [20 Sec] Emulation Type [Auto]...
Page 97
Configure Advanced CPU settings Sets the ratio between CPU Core Manufacturer: Intel Clock and the FSB Brand String: Genuine Intel(R) CPU 3.80GHz Frequency. Frequency : 3800 MHz NOTE: If an invalid FSB Speed : 800 MHz ratio is set in CMOS then actual and Cache L1 : 16 KB...
Page 102
Enable or disable Configure Win627EHF Super IO Chipset High Definition Audio HD Audio Controller [Enabled] Controller. Front Panel Support Type [HD Audio] Onboard 1394 Controller [Enabled] Onboard PCIE GbE LAN_1 [Enabled] LAN Option ROM [Disabled] Onboard PCIE GbE LAN_2 [Enabled] LAN Option ROM [Disabled] Marvell SATA/PATA Controller [Enabled]...
Page 104
Advanced PCI/PnP Settings NO: Lets the BIOS configue all the WARNING: Setting wrong values in below sections devices in the system. may cause system to malfunction. YES: Lets the Plug And Play O/S [No] operating system PCI Latency Timer [64] configure Plug and Allocate IRQ to PCI VGA [Yes]...
Page 105
Suspend Mode [Auto] Select the ACPI state Repost Video on S3 Resume [No] used for System ACPI 2.0 Support [No] Suspend. ACPI APIC Support [Enabled] APM Configuration Hardware Monitor 4-33...
Page 106
APM Configuration Go into On/Off or Suspend when Power Power Button Mode [On/Off] button is pressed. Restore on AC Power Loss [Power Off] Power On By RTC Alarm [Disabled] Power On By External Modems [Disabled] Power On By PCI Devices [Disabled] Power On By PCIE Devices [Disabled]...
Page 109
Hardware Monitor CPU Temperature AI Quiet [Disabled] CPU Temperature [54ºC/129ºF] MB Temperature [37ºC/98.5ºF] CPU Fan Speed (RPM) [2884RPM] CPU Q-Fan Control [Disabled] Chassis Fan1 [N/A] Chassis Fan2 [N/A] Chassis Q-Fan1 Control [Disabled] Power Fan Speed (RPM) [N/A] VCORE Voltage [ 1.488V] 3.3V Voltage [ 3.312V] 5V Voltage...
Page 111
Specifies the Boot Boot Settings Device Priority Boot Device Priority sequence. Boot Settings Configuration A virtual floppy disk Security drive (Floppy Drive B:) may appear when you set the CD-ROM drive as the first boot device. Specifies the boot Boot Device Priority sequence from the 1st Boot Device [1st FLOPPY DRIVE]...
Page 112
Boot Settings Configuration Allows BIOS to skip certain tests while Quick Boot [Enabled] booting. This will Full Screen Logo [Enabled] decrease the time AddOn ROM Display Mode [Force BIOS] needed to boot the Bootup Num-Lock [On] system. PS/2 Mouse Support [Auto] Wait For ‘F1’...
Page 113
Security Settings <Enter> to change password. Supervisor Password : Not Installed <Enter> again to User Password : Not Installed disabled password. Change Supervisor Password 4-41...
Page 114
Security Settings Supervisor Password : Not Installed User Password : Not Installed Change Supervisor Password User Access Level [Full Access] Change User Password Clear User Password Password Check [Setup] Boot Sector Virus Protection [Disabled] Select Screen Select Item Change Option General Help Save and Exit Exit...
Page 116
Exit Options Exit system setup after saving the Exit & Save Changes changes. Exit & Discard Changes Discard Changes F10 key can be used for this operation. Load Setup Defaults Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit 4-44...
Page 140
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. MAIN MENU 1. Create RAID Volume 2. Delete RAID Volume 3. Reset Disks to Non-RAID 4. Exit DISK/VOLUME INFORMATION RAID Volumes: None defined. Physical Disks: Port Drive Model Serial # Size...
Page 141
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. CREATE ARRAY MENU Name: Volume0 RAID Level: RAID0(Stripe) Disks: Select Disks Strip Size: 128KB Capacity: Create Volume DISK/VOLUME INFORMATION Enter a string between 1 and 16 characters in length that can be used to uniquely identify the RAID volume.
Page 142
• • • WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST. Are you sure you want to create this volume? (Y/N): 5-22...
Page 143
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. CREATE ARRAY MENU Name: Volume1 RAID Level: RAID1(Mirror) Disks: Select Disks Strip Size: Capacity: XX.X Create Volume DISK/VOLUME INFORMATION Enter a string between 1 and 16 characters in length that can be used to uniquely identify the RAID volume.
Page 144
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. CREATE ARRAY MENU Name: Volume10 RAID Level: RAID10(RAID0+1) Disks: Select Disks Strip Size: 128KB Capacity: XXX.X GB Create Volume DISK/VOLUME INFORMATION Enter a string between 1 and 16 characters in length that can be used to uniquely identify the RAID volume.
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST. Are you sure you want to create this volume? (Y/N): Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. CREATE ARRAY MENU Name: Volume5 RAID Level: RAID5(Parity) Disks:...
Page 146
SELECT DISKS Port Drive Model Serial # Size Status 0 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk 1 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk 2 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk 3 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk Select 2 to 4 disks to use in creating the volume. [↑...
Page 147
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH7R wRAID5 Copyright(C) 2003-05 Intel Corporation. All Rights Reserved. DELETE VOLUME MENU Name Level Drives Capacity Status Bootable Volume0 RAIDX(xxxxx) XXX.XGB Normal HELP Deleting a volume will destroy the volume data on the drive(s) and cause any member disks to become available as non-RAID disks.
Page 148
RESET RAID DATA Resetting RAID data will remove internal RAID structures from the selected RAID disks. By removing these structures, the drive will revert back to a non-RAID disk. WARNING: Resetting a disk causes all data on the disk to be lost. Port Drive Model Serial # Size Status...
Page 149
RESET RAID DATA Resetting RAID data will remove the internal RAID structures from the selected RAID disks. By removing these structures the drive will revert back to a Non-RAID disk. WARNING: Resetting a disk causes all data on the disk to be lost. Port Drive Model Serial # Size...
Page 150
Loading FreeDOS FAT KERNEL GO! Press any key to boot from CDROM... 1) Make ICH7 32-bit RAID driver disk 2) Make ICH7 64-bit RAID driver disk 3) Format floppy disk 4) FreeDOS command prompt Please choose 1 ~ 4 Insert new diskette for drive B:\ and press ENTER when ready...