Table of Contents
Advertisement
Removing a Drive from the Upper Drive Bay
To remove a drive from the upper drive bay, follow these steps:
1. Remove both the ribbon cable connector and the power
cable connector from the drive.
Remove the screws securing the drive.
2.
3. Reach behind the drive and gently push it to the front of the
bay; then pull it out of the slot.
4. Once you have removed the drive, replace the faceplate by
inserting one side of the plate, then gently guiding the other
side into place. You will hear it snap into place.
Post-installation Procedures
After you install or remove your drive(s) and replace the cover
on your computer, you need to run the SETUP program to
define the correct configuration for your newly-installed drive.
See Chapter 1 for instructions.
installing and Removing Drives
4-17
Advertisement
Table of Contents
