Remote Control Information - Epson PowerLite 600p User Manual
Epson user's guide multimedia projector powerlite 600p, powerlite 800p, powerlite 810p
Hide thumbs
Also See for PowerLite 600p:
- Product information (13 pages) ,
- Brochure (6 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Remote Control Information
You can operate the projector by remote control via a line-of-sight infrared
(IR) receiver at the front and rear of the projector. The projector may not
respond to remote control commands under the following conditions:
I
There is an object between the remote control IR emitter and the IR
receiver on the projector.
I
Ambient light is too bright.
I
Certain types of fluorescent lighting are used.
I
A strong light source shines into the IR receiver.
I
Other equipment that emits infrared energy, such as a radiant room
heater, is in the room.
These conditions commonly cause problems for most infrared-controlled
equipment. Try the following:
I
Make sure the remote control is turned on.
I
The remote control unit's batteries may be low on power; replace them.
I
Dim the ambient lighting and/or turn off any fluorescent lights.
I
Close any window coverings and/or move the projector out of direct
sunlight.
I
Turn off other equipment that emits infrared energy.
If the remote control still does not work properly, remember you can always
control your computer-based presentation directly from the computer, even
in an environment containing one of the conditions listed above.
Appendix B: Notices
97
Hide quick links:
Advertisement
Table of Contents
