hit counter script

Adjusting Air Pressure; Loading Nails - Hitachi NT 50AE2 Instruction And Safety Manual

Hide thumbs Also See for NT 50AE2:
Table of Contents

Advertisement

Available languages

Available languages

English

ADJUSTING AIR PRESSURE

Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar
5 – 8.5 kgf/cm
2
) according to the length of nails and the hardness of workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a
higher than required air pressure unnecessarily over stresses the Nailer.

LOADING NAILS

● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Lightly press the stop lever and gently pull out the magazine cover.
(2) Set nail strip into the magazine and keep the points of nails in contact with Groove.
16
Magazine cover
Nail strip
Magazine
WARNING
● Do not exceed 120 psi
(8.3 bar 8.5 kgf/cm
WARNING
Press
Pull out
Stop lever
Groove
2
).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nt 32ae2Nt 50ae2 (s)Nt 32ae2 (s)

Table of Contents